Advertisement
OPERATION OF YOUR KETTLE
1. To use the kettle, remove it from the power base and open lid by pressing the button
at the top of lid handle. Fill with the desired amount of water, and then close the lid.
Alternatively, the kettle may be filled through the spout. The water level should not
exceed the maximum mark or sit below the minimum level. Too little water will result in
the kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout
when boiling. Ensure that the lid is firmly in place before plugging into the power outlet.
2. Position the kettle on the power base.
3. Connect the plug into a power outlet. Press down the switch and the indicator will
light up. The kettle will switch off automatically once the water has boiled.
4. Lift the kettle from the power base before pouring the water.
5. The kettle will not re-boil until the switch is pressed again. The kettle may be stored on
the power base when not in use.
NOTE: Ensure that the switch is free of obstructions and the lid is firmly closed. The
kettle will not turn off if the switch is constrained or the lid is open.
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate without water, the boil-dry protection will
automatically switch off the power. If this occurs, allow the kettle to cool before filling
with cold water and re-boiling.
Page 3 of 5
Advertisement
