Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SkyArtec WASP v2
Summary of Contents for SkyArtec WASP v2
- Page 1 WASP v2 manual WASP v2 helicopter operating manual Page 1...
-
Page 2: Table Of Contents
WASP v2 manual contents: Introduction Technical specifications LIPO battery Radiocontrol Check list before take off Flight functions First steps Learning to fly a helicopter Spareparts and part numbers Mounting of the CP Rotorhead CE declaration Page 2... -
Page 3: Introduction
WASP v2 manual 1. Introduction The WASP microhelicopter consists of mechanical and electrical components. The helicopter is preadjusted but it is necessary to check the helicopter before each flight. The helicopter you purchased is a full functional RC helicopter of the newest generation. Due to its fixed main rotor pitch it is not 3D flight capable, which means you can´t fly the model head over. -
Page 4: Radiocontrol
WASP v2 manual 4. Radiocontrol The radiocontrol included in this set uses a 4 channel PCM trans- mission protocol to provide a fail-safe usage of your helicopter. Please insert 8 pieces AA-type batteries into the radiocontrol. The frontside voltage display shows you the current battery condiditon. -
Page 5: Flight Functions
WASP v2 manual 6. Flight functions LEFT LEVER RISE LEFT LEVER LOWER DOWN LEFT LEVER YAW LEFT LEFT YAW RIGHT LEFT LEVER RIGHT NICK FOR- RIGHT LEVER WARD NICK BACK- RIGHT LEVER DOWN WARD ROLL LEFT RIGHT LEVER LEFT ROLL RIGHT... -
Page 6: First Steps
WASP v2 manual 7. First steps If you are using a radiocontrolled item the first time, please train and learn the control functions on a simulator software. Through that you will learn which lever belongs to which function without de- stroying the helicopter accidentally. -
Page 7: Spareparts And Part Numbers
WASP v2 manual Advice: The helicopter´s swashplate can be set up in two ways. The long position will cause a stron- ger reaction for nick and roll to the radio´s commands. You just need to change the long connectors from the ball point head to the next one. - Page 8 WASP v2 manual Page 8...
-
Page 9: Mounting Of The Cp Rotorhead
WASP v2 manual 10. Mounting of CP rotorhead Mount bearings. Mount pitch frame on bearing. Check if position as shown. Mount the pitch frame´s tap and put the screws into it. Fasten screws. Mount bushings on compensator. Put the grub screw in the bushings and an fasten it slightly. -
Page 10: Ce Declaration
WASP v2 manual 11. CE declaration of conformity Page 10...
Need help?
Do you have a question about the WASP v2 and is the answer not in the manual?
Questions and answers