Advertisement
© by The Toro Company
20
22
Should the motor have stopped due to the conditions inside the
mower housing and block when restarting, it is absolutely necessa-
ry to clear the mowing tunnel from grass rests (Fig. 20).
To clean the mower, disconnect the mains plug.
Change the mowing direction frequently (Fig. 21).
In case of an unsatisfactory mowing result:
1. Resharpen the cutters (Ensure not to create an unbalance).
2. Mow at a slower pace.
3. Increase the cutting height by one or two steps.
4. Mow your lawn in shorter intervals.
5. Mow only 2/3 or half the mowing width, in order to give the
mower the opportunity of self-cleaning.
4.3
Mowing with the grass-collecting device
21
Never remove the grass-collecting device while the
motor is running - danger of injury!
1. Ensure that the motor and the cutter stand still. Remove
the Recycler-plug!
2. Clean the grass ejection area from grass rests.
3. Hang the grass-collecting device into the mounting on the
mower housing (Fig. 22).
4. Close the ejection door up to the grass-collecting device.
To empty the grass-collecting device, turn the motor off and
wait until the cutter stands still.
Disconnect the mains plug when leaving the mower.
Remove the grass-collecting device and tilt it a bit to the back so
that no grass will fall out.
Dump the full grass-collecting device by shaking it slightly
(Fig. 23).
23
13
Advertisement
