Advertisement
Advertisement
Table of Contents
Related Manuals for ECOVACS LSD4RF-25410N15
Summary of Contents for ECOVACS LSD4RF-25410N15
- Page 1 LSD4RF-25410N15 2.4G Module User Manual...
- Page 2 FCC STATEMENT This device complies with part 15 of the FCC rules and Industry Canada Licence-exempt RSS standard(s). Operation is subject to the following to conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation.
- Page 3 Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
- Page 4 Introduction LSD4RF-25410N15 Wireless Module is designed based on TI Transceiver CC2500and CC2590. It is a high performance 10mWSMD IOT wireless Transceiver that can be used in a wide range of short distance IOT communication. It has low power consumption, high resistance to disturbance ,small in size and low cost.
- Page 5 Manufacture Guidance The label contained the FCC ID will be installed on the module as below method. And the module will be installed on the control panel as the method below. The Figure shows the temperature graph when manufacture by reflow soldering method.
- Page 6 The Information of Antenna Electrical Specification The antenna is printed on the module. The antenna is installed inside the host unit and the final user can not install the antenna themselves. The module and antenna are installed with a distance over 20cm from the user during use.
- Page 7 The Information of FCC ID The FCC ID of the module will be contented in the host unit. Robotic Housekeeper（3G+Wi-Fi） Model：F588 Input：14.5V DC 0.75A Charging Dock： CH1205B Battery：12VDC，2500mAh，Ni-MH Producing date: 11/2012 User Name: ××××××0001 Contains FCC ID:2AAL3-LSD4RF. Contains IC:12253A- LSD4RF MADE BY ECOVACS...
Need help?
Do you have a question about the LSD4RF-25410N15 and is the answer not in the manual?
Questions and answers