Advertisement
1
2
3
Rear Panel
DC In
1
Charging Port
2
AUX Audio Jack
3
Listening to your device wirelessly over Bluetooth
To listen to your music over Bluetooth wireless connection, you need to pair your device
with Sharper Image Ambience:
1. Make sure your device has Bluetooth capability.
2. Press the POWER button to turn on the unit. The Bluetooth light will flash slowly
after 5 seconds.
3. Once the Bluetooth button beings to flash, press and HOLD the Bluetooth button for a
few seconds until the Bluetooth light begins to flash quickly.
4. Follow the instructions of your device to pair the unit.
5. Pair your device with the unit by selecting from your Bluetooth listings on your device
or selecting YES.
6. Press play on your device and use controls on the unit or remote to adjust to desired
volume.
7. The effective range of the Ambience is approximately 30-feet from the Bluetooth
device. Range can be affected by numerous factors including the Bluetooth device,
wall materials, etc. If you experience audio drop outs please move the Bluetooth
device closer to the Ambience
NOTE: Once you have successfully paired your device, you typically will not need to
repeat the above steps. Please ensure the unit source is set to Bluetooth and your
device has Bluetooth enabled.
Power
1
Bluetooth Button
2
1
9
Bass Controls
3
2
8
AUX
Skip/Search
4
Down Button
3
7
BASS
Play/Pause Button
5
Skip/Search
6
4
6
Up Button
5
Volume Controls
7
AUX Button
8
Mute Button
9
4
Listening to your device through the Auxiliary AUX In Audio Jack
1. Referring to rear panel image, connect AUX cable to the headphone or line-out jack
of an audio device and plug the other end of the cable into the AUX In Audio jack on
the back of the unit.
2. Press the POWER button to turn on the unit.
3. Press the AUX button, AUX indicator will illuminate.
4. Press PLAY on the device and use controls on the unit or remote to adjust to desired
volume.
Adjusting Bass
While playing audio, press the BASS controls on the remote to adjust to desired bass
level.
Remote Control Battery:
The battery is already installed. Simply pull tab out to
activate battery power. To replace remote battery, open the
battery door by pressing the two tabs together. Remove
the old battery and replace with the same (CR-2025)
battery type.
Battery Precautions
• Use only the size and type of batteries specified.
• When installing batteries, observe proper +/- polarities.
Incorrect installation of battery may cause damage to
the unit.
• Do not mix different types of batteries together (e.g.,
alkaline with carbon-zinc or old batteries with new ones).
• If the unit is not going to be used for a long period of
time, remove batteries to prevent damage due to pos-
sible battery leakage.
• Do not dispose of batteries in fire. Batteries may explode
or leak.
This product contains small parts that may present a choking hazard for young
children. If swallowed, it could cause severe injury or death. Seek medical
attention immediately.
AUX
BASS
Remove
5
Advertisement
