Advertisement
DIP Settings:
DIP
1
External RGB connected.
(when using external
GPS/Android box)
2
External video source 1
enabled (DVD/Digital TV etc)
3
External video source 2
enabled (DVD/Digital TV etc)
4
RGB Input Resolutions
800*480
5
Reverse camera installed
6
Set On Once for IR
programming and ON/OFF 5
times for touch panel
calibration
7,8
No Function (Keep UP(OFF) in all cases)
Power Definition for 6PIN power connector between CANBOX and Interface:
YELLOW
12V power supply (Battery)
RED: ACC =12V when key in ignition state
BLACK Ground to Chassis.
GREEN
Can box generated reverse trigger signal [when =12V the reverse video is enabled], this wire is automatically
generated by CAN bus.
WHITE:
This wire is the switch signal, when the user presses call off key. Can switch video source.
GRAY
CAN box's communication data with guideline angle.
DIP Down= ON
ON
Internal GPS module
Enabled.
External video source 1
Disabled
External video source 2
Disabled
RGB Input Resolutions
480*240 or 400*240
Reverse camera not
installed
Set off for normal use
(touch calibration is for
DVD/TV for Video1 and
Video2)
when=12V the interface works.
DIP UP= OFF
OFF
UP(OFF)
UP(OFF)
UP(OFF)
DOWN(ON)
DOWN(ON)
UP(OFF)
Default
Advertisement
