Connection Diagram; Terminal Connection Diagram For Pa105 & Pa106 - Processautomatic PA105 Manual

9 Connection Diagram:

9.1 Terminal Connection diagram for PA105 & PA106:
When purchased as a silicon filled version – then the signal and supply cables will already
have been connected to the terminal. However – if purchased without a silicon filled version
– and the terminal connection is intended to be performed by the customer – it is very
important to connect the signal & supply cables as instructed & illustrated.
1. Connect the signal cables copper wires to terminals 4 & 6.
2. Connect the signal cable screen to terminal 5.
3. Connect the output signal cable copper wire to terminal 3.
4. Connect the (-) negative supply cables copper wire to terminal 2.
5. Connect the (+) positive supply cables copper wire to terminal 1.
NOTE: The diagram illustrates a PA105 Pre-Amplifier – However, the terminal on the PA105 Pre-Amplifier & the
PA106 Pre-Amplifier are identical.
NOTE: Failure to connect as illustrated and instructed can result in short circuit – or cause loss of signal / loss of
indication of actual flow.
Page 6 of 9