Table of Contents
Advertisement
Preamble
Set the wireless radio preamble type. The preamble type in
Type
802.11 based wireless communication defines the length of
the CRC (Cyclic Redundancy Check) block for communication
between the access point and roaming wireless adapters. The
default value is "Short Preamble".
Guard
Set the guard interval. A shorter interval can improve
Interval
performance.
802.11n
Enable/disable 802.11n protection, which increases reliability
Protection
but reduces bandwidth (clients will send Request to Send
(RTS) to access point, and access point will broadcast Clear to
Send (CTS), before a packet is sent from client.)
CE Adaptive
The measurement procedure follows clause 5.3.11.2.2 of the
ETSI EN 300 328 V1.8.1
DTIM Period
Set the DTIM (delivery traffic indication message) period value
of the wireless radio. The default value is 1.
RTS
Set the RTS threshold of the wireless radio. The default value
Threshold
is 2347.
Fragment
Set the fragment threshold of the wireless radio. The default
Threshold
value is 2346.
Multicast
Set the transfer rate for multicast packets or use the "Auto"
Rate
setting.
Tx Power
Set the power output of the wireless radio. You may not
require 100% output power. Setting a lower power output can
enhance security since potentially malicious/unknown users
in distant areas will not be able to access your signal.
Beacon
Set the beacon interval of the wireless radio. The default
Interval
value is 100.
Station idle
Set the interval for keepalive messages from the access point
timeout
to a wireless client to verify if the station is still alive/active.
175
Office 1-2-3 Interface
Advertisement
Table of Contents
