Simkits USB Altimeter Construction Manual page 3

Normal SERVO
Twist the servo clockwise by hand until it blocks.
9
-Normal SERVO
-Modified SERVO
Remove disc and screw.
These parts are no
longer required.
10
Modify an HS300 or HS311 servo,
or order a modified servo
through the SimKits webshop.
See separate manual for
instructions on modifying a servo.
11
0.26"
(6.5 mm.)
Boor het linker-benedengat
(van voren af gezien) van front-
ring A1 op, totdat dit een maat
heeft van 0.26" / 6.5 mm.
12
Altimeter Construction Manual
41
Place optical F into front ring A1
en cement it by sparingly
applying glue to the back f the
front ring, in the edge where
A2
optical and front ring connect.
1
A1
13
Connect cord A6 to light A5 by soldering.
Use sleeve A7 to insulate the soldered
connection, but leave roughly 8 mm's
worth of wire free at the base of the light.
A6
The sleeve shrinks when heated.
14
Connect the wires
to the circuit board.
Polarities are
not important.
15
Place the rotary encoder assembly's
connector onto the circuit board
as indicated.
16
S
SIMULATOR PARTS
2
A7
A5
D
A5/A6/A7
A8
Page 3