Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Stability bracket
If the cooker is fitted with a flexible
connection, a stability bracket should
be fitted to engage in the back of the
cooker.
A stability bracket can be
bought from your local supplier.
A stability bracket can be fitted as
follows:
1. Place the cooker in position and
draw a pencil line level with the
front edge.
2. Mark the centre of the cooker to give
the centre line for the bracket.
3. Remove the cooker and mark off
450mm from the pencil line to
locate the front edge of the lower
bracket.
Rear wall
Front edge for
lower bracket
3
450
mm
4. Fix the bracket to the floor.
Measure from floor level to
engagement edge in the back of
the cooker and add 3mm.
5. Assemble the underside of the top
part of the bracket to this height.
Levelling
Place a spirit level on a baking sheet
onto an oven shelf.
The cooker is fitted with levelling feet
and locknuts at the front, and wheels
at the rear.
Adjustment of wheel height can be
made with a screwdriver through the
hexagonal hole in the front plinth.
Stability bracket
60
mm
1 Pencil line
on floor
2 Centre
line
5 Underside of top bracket
4
slots into engagement
edge in back of cooker.
18
USING THE GRIDDLE (if fitted)
Caution: Accessible parts may
be hot when the griddle is used.
Young children should be kept
away.
The appliance may be supplied with a
griddle.
Griddle symbol
Only use the griddle which has been
approved for use on this appliance.
Do not use any other griddle, as this
may be hazardous.
Please read these instructions thoroughly
before using the griddle for the first time.
Refer to the cleaning section for
griddle care and cleaning instructions.
For instructions on griddle cooking,
please refer to the accompanying
cooking guide.
Before using the griddle for the
first time
Wash the griddle thoroughly in hot
soapy water (see "Cleaning" section).
Season sparingly with a minimum
amount of cooking oil (see below).
Heat the griddle on full rate for 3 minutes.
The griddle plate is now ready for use.
Seasoning the griddle
The griddle is made of quality cast iron,
and has a non-stick cooking surface.
Regular seasoning will prolong the life
of the griddle and prevent rusting. If
the griddle shows signs of rust, wash
and re-season.
To season;
After cleaning, dry the griddle
thoroughly.
Rub the cooking side of the griddle
sparingly with a minimum amount
of unsalted vegetable oil. Note that
olive oil is unsuitable for seasoning.
Using the griddle
The griddle should only be positioned
front-to-back over the burners
indicated by the griddle symbol on the
fascia panel.
Do not use the griddle over the large
burners.
Place the griddle carefully on the pan
support over the burners, using the
locating feet on the underside of the
griddle. Take care to avoid damage
to the vitreous enamel surface of the
pan supports.
Before cooking, preheat the griddle
for 3 minutes on full rate, which is
indicated on the control knobs by a
large flame symbol.
After preheating, turn the control
knobs to the small flame symbol.
The griddle is now ready for cooking.
Do not use metal implements, as they
may damage the non-stick surface.
After cooking, allow the griddle to
cool before moving or cleaning it.
7
Hide quick links:
Advertisement
Table of Contents
