Table of Contents
Advertisement
If your model does not have a water softening facility, you may skip this part.
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes
and utensils.
The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the
water.
Always use salt which is intended for use with dishwashers - never use ordinary table salt.
The salt container is located beneath the lower rack and should be filled as follows:
1
Remove the lower basket and then unscrew and remove the cap from the salt
container.
2
If you are filling the container for the first time ,fill 2/3 of its volume with water
(around 500ml).
3
Place the end of the funnel(supplied) into the hole and add about 1.2kg of
salt .It is normal for a small amount of water to spill out of the salt container
4
5
1
. The salt container must be filled when the warning light is illuminated. On some occaisions, the
warning light may remain lit until the salt has fully dissolved.
2
. Should any salt spill into the inside of the appliance, run the soak program and this will rinse the salt
safely away.
1
Unscrew the cap from the salt container.
2
There is a ring on the container with an arrow on it (see Figure to the side), if
necessary, rotate the ring in the anticlockwise direction from the "-" Setting
toward the "+" sign, based on the hardness of the water being used.It is
recommended that adjustments should be made in accordance with the following
schema:
4
Advertisement
Table of Contents
