CONTENTS Safety Warnings Electrical Safety Transportation and Handling Installing and Switching on Your Appliance Before Switching On Door Height Adjustment Your Appliance and the Compartments Adjusting the Temperatures and Functions Shelving and rack adjustment Bulb Replacement Installation Instructions for External Filter Energy Saving Advice Freezer Storage Advice Power Failure...
Safety warnings Important note: Please read this booklet before installing and switching on this appliance. The manufacturer assumes no responsibility for incorrect installation and usage as described in this booklet. • This model uses natural refrigerant gas as part of its cooling system. This gas is known as R600a(Isobutene) and is environmentally friendly but can be combustible.
•Place your appliance in an area that is not exposed to direct sunlight. •Your appliance should be placed at least 10cm away from stoves, ovens and other heating cores. •This appliance should never be used outdoors or left in the rain.
Before Switching On •Before using your appliance, add a teaspoon of bicarbonate of soda to warm water and with a damp cloth wipe down all parts of the new appliance, then repeat the process with a clean damp cloth and dry(ensure the appliance is not connected to the power when performing this task).
When the fridge door is low: Open the door, use a wrench to rotate the adjusting nut anti-clockwise to raise the height of the door. Once the doors are aligned, then tighten the locking nut by rotating it clockwise. When the fridge door is high: Open the door, use a wrench to rotate the adjusting nut clockwise to lower the height of the door.
Operation Instructions Shelving and rack adjustment Important note: all food and drink should be removed from all shelves and racks before adjusting or removing them You can adjust the shelving in the fridge compartment to your required configuration. To remove a shelf, lift it up slightly so the plastic stabilisers that on either side of the shelf are above the shelf rails and then pull it towards you.
Installation Instructions for External Filter Installation Tools a. Electric drill; b. Cross screwdriver; c. Straight screwdriver; 1. Use screws to fasten the clips on the wall; 2. Install the filter into the clips; 3. Insert one end of quick-connection elbow into the water inlet of filter, then insert the water inlet pipe into the other end of quick-connection elbow till it reaches to the positioning mark, and then lock it with a buckle;...
Energy Saving Advice •Do not install the appliance close to sources of heat, such as a cooker, dishwasher or radiator. •Locate the appliance in a cool well-ventilated room and make sure that the air vents are clear. •Try to avoid keeping the doors open for a long time, as warm air will enter the cabinet and may cause a build-up of ice as well as affecting the energy consumption.
Maintenance & Cleaning Disconnect the appliance from the power supply before cleaning. Internal Cleaning •Do not pour water over the appliance. •The cavity should be cleaned periodically using a solution of bicarbonate of soda and lukewarm water (5ml to 0.5 litre of water) •Clean the accessories separately with soap and water.
Trouble shooting Problem Solution Check that the appliance is switched on. Check that there has not been a power cut. Check that the plug is not faulty. The fridge/freezer does Check that the fuse has not blown. not work Check that the voltage is correct for the appliance. Are there any faults with the socket? For this purpose, try the plug of your appliance by connecting it to a socket which you are sure is working.
Trouble shooting Problem Solution Ensure there are no obstructions preventing door closure. Check the door compartments and shelves are correctly The doors do not close in place. properly Check the door seal is not warped or torn. Check the appliance is level. Check that the appliance is on a flat, level surface and is stable.
Need help?
Do you have a question about the SXS905 SS and is the answer not in the manual?
Questions and answers