Electric Start - Powermate PMC496751 Owner's Manual

ELECTRIC START

This generator model is provided with both electric start
and recoil start capabilities. The charger is a low amperage
(1A) maintenance type charger. It will charge your battery as
your generator runs. Avoid prolonged cranking, as it can
damage the engine.
The battery provided is a nominal 12 volt sealed
rechargeable lead-acid battery and can be operated in any
position without leakage. It complies with non-spillable battery
regulations. Its convenient size offers a 30% reduction over
conventional batteries.
Length = 7.14 inches, Width = 3.03 inches,
Height = 6.59 inches, Weight = 12.56 lbs
18AH Rating
UL Recognized
Battery Kit Parts List
Item Description
A *Bolt, M5 x M12
B. *Nut 5MM
C. *Washer Flat M5
* These are standard parts available at your local hardware
store.
Note: Brand New Generators are shipped with the Battery
Connections disconnected. The Positive and Negative
Terminals must be connected to the Battery before the
Electric Start Feature will work.
Initial Battery Connection - Refer to the Installation Instructions
Below.
Battery Removal & Installation:
Removal: Remove the nut and bolt from the negative and
positive post, being careful not to short across the terminals.
(Shorting the terminals together can cause sparks, damage to
the battery or generator or even burns or explosions.)
Always abide by the safety warnings provided with the
battery. Remove the battery and re-cycle and dispose of
properly.
• Do not short-circuit the battery terminals.
• Do not charge in a sealed container.
• Keep sparks, flame away.
4
Installation:
Hook up the new battery, or re-install the new battery, as
follows: Place the battery in the position provided. Connect the
Red 10 Gauge wire to the positive (+) terminal and the Black 10
Gauge wire to the negative (-) terminal with the bolt, nut, and
washer provided. Make sure all connections are tight. Your
battery is now connected and ready for use. Turn the start
rocker switch to the on position and push the start button to
crank the engine.
Note: Be sure Oil has been added to the engine as
specified in the Owner's Manual.
Qty
2
2
2
English