Advertisement
PURE HOME NETWORKING VIDEO COMBINER, SPLITTER, AND BOOSTER MODULES
• For your safety, do not use this or any electrical
product near water (unless it is specifically
designed for wet areas). Do not install wiring
during thunder and lightning storms.
• Use caution when handling or installing any
computer, telephone, video, or electrical devices.
3.3 Installing a Module in the Pure Home Networking Box
1. Determine the area for installation.
2. Position the metal tabs on the left side of the
module at a 45-degree angle and slide them into
the rail holes on the Pure Home Networking Box.
3. Insert the metal tabs on the right side of the
module into the rail.
4. Press the button to fasten the module to the Pure
Home Networking Box.
3.4 Removing a Module from the Pure Home Networking Box
1. Press the button and hold it in while pulling the
module from the Pure Home Networking Box.
2. Swing the module out.
3.5 Module Configuration
There are two basic types of video configurations,
single-input and multiple-input. Which one you use
depends on your individual needs.
3.5.1 S
-I
C
INGLE
NPUT
ONFIGURATION
This configuration simply takes a single inbound
video signal and distributes it out to eight individual
outlets. It's perfect for cable TV or video distribution.
You'll need the 1 x 8-Port Bidirectional Video CATV
Splitter (Passive) Module (JHN2048A) only. See
Figure 3-1.
1. Take the incoming video line and connect it to
the center post.
2. Connect the outbound connectors to the
individual outlets. (The module supports up to
eight outlets.)
3. Join the cables neatly together with cable ties
using the cable management channel
anchoring ports.
Input
1 GHz
Bandwidth
1
2
3
Bi-Directional
4
5
Video Module
6
7
8
Booster optional
*
Figure 3-1. Single-input setup.
3.5.2 M
-I
C
ULTIPLE
NPUT
ONFIGURATION
This configuration uses multiple modulated input
devices such as DVD players, VCRs, or surveillance
cameras, combining them with cable TV and/or cable
modems, and distributing them to eight individual
outlets.
You will be using a 1 x 2-Port Video Combiner (Passive)
Module (JHN2046A), a 1 x 8-Port Bidirectional Video
CATV Splitter (Passive) Module (JHN2048A), and a
Video Signal Booster, 1-Port Module (JHN2060A). You
will also need a signal modulator (call Tech Support for
details).
For best results, start at the top and work down.
1. Obtain a multi-input modulator (call Tech Support
for details). The modulator allows you to assign
television channels to individual devices.
2. Next, install the 1 x 2-Port Video Combiner
(Passive) Module. Connect the output cable from
the modulator to the modulated input connector
on the combiner.
3. Connect digital or analog cable to the cable TV
post on the video combiner.
CAUTION
Do not plug the cable TV or Internet cable into the
modulated port.
4. Install the Video Signal Booster, 1-Port Module by
connecting a cable from the video combiner
output post to the booster input.
Cable Management
Channel
To Outlets
#1 - #8
3
Advertisement
