Schwan SC30 Installation Manual page 5

DIAGRAM 2
DIAGRAM 3
DIAGRAM 4
70mm MAX
DIAGRAM 5





FLAT

SURFACES
- O-ring

5
DRILL 35MM HOLE FOR DISPENSER
You will need to drill a 35mm diameter hole in the bench top
or sink insert where you would like to place the dispenser.
The dispenser must be within 600mm of the proposed
location of the Schwan under bench boiling tank, and filter
system. (Ref Diagrams 11 and 14)
IMPORTANT
Surfaces must be flat and level (Ref Diagrams 3 and 4)
The thickness of the bench top or sink insert where the
dispenser is to sit must be less than 70mm.
The surface that the dispenser base is to be fitted to must
be flat and level and large enough to accommodate the
diameter (50mm) of the dispenser base assembly.
The surface under the bench top or sink insert where the
base assembly clamping plate will sit must also be flat and
level and large enough to accommodate the diameter
(45mm) of the clamping plate.
INSTALLING DISPENSER BASE ASSEMBLY
Fold base clamping plate to allow it to pass through the
35mm diameter hole and locate the O-ring seal under the
base assembly as shown in Diagram 5.