HBC micron 4 Operating Instructions Manual

HBC micron 4 Operating Instructions Manual

Industrial radio controls radio transmitter

Advertisement

Operating Instructions
Radio Transmitter micron 4
BE-MICR4_I-V2-2.DOC [ Word 97 ] FL
STOP
1
2
micron
made by HBC
0
1
31.394
HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY
Information and specifications subject to change without notice.
Industrial
HBC

– Radio Controls

R
a
d
i
o
T
r
R
a
d
i
o
T
r
1
2
a
n
s
m
i
t
t
e
r
a
n
s
m
i
t
t
e
r
Industrial
m
i
c
r
o
n
4
m
i
c
r
o
n
4
Radio System
Page 1 / 18
2000-08-15

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the micron 4 and is the answer not in the manual?

Questions and answers

Summary of Contents for HBC micron 4

  • Page 1: Radio Controls

    Radio Transmitter micron 4 Industrial BE-MICR4_I-V2-2.DOC [ Word 97 ] FL Page 1 / 18 – Radio Controls Industrial STOP micron made by HBC 31.394 Radio System HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY Information and specifications subject to change without notice. 2000-08-15...
  • Page 2: Operating Instructions

    Tel. +49 ( 0 ) 79 51 – 3 93 - 0 Fax +49 ( 0 ) 79 51 – 3 93 – 50 E-mail: info@radiomatic.com http://www.hbc-radiomatic.com HBC radiomatic GmbH is not liable for any misprints or errors! – All rights reserved. ™ radiomatic is a registered German trademark. ©...
  • Page 3: Table Of Contents

    In the Event of a Fault ..............16 Technical Data ................17 Accessories ..................17 Dimensions and Operator Controls of micron 4 ........ 18 Radio System HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY Information and specifications subject to change without notice.
  • Page 4: Description

    The transmitter has general telecommunications approvals. It is not necessary to have or to apply for a license to operate the micron 4 transmitter with the respective receiver. The transmitter must be operated in the 433,100 MHz to 434,750 MHz range or 869 MHz to 870 MHz bandwidth.
  • Page 5: Safety Instructions

    Pay attention to the comments and instructions given. Ignoring the information provided may permanently impair the reliability and operability of the equipment. Radio System HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY Information and specifications subject to change without notice. 2000-08-15...
  • Page 6: General Safety Instructions

    ! Ø A defective transmitter may only be repaired by qualified and competent personnel. Use only original HBC spare parts. The use of any other spares will render the technical inspectorate approval invalid as well as substantially impede operative safety.
  • Page 7: Operator Safety Instructions

    As you are no longer in the crane and can no longer sense the starting of the crane movements as distinctly, crane reactions will appear sluggish or dull. Radio System HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY Information and specifications subject to change without notice. 2000-08-15...
  • Page 8: Operation

    Note : Always use the key switch (pos. Á) to switch the transmitter ON or OFF. Do not use the STOP pushbutton ! Radio System HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY 2000-08-15 Information and specifications subject to change without notice.
  • Page 9: Scanner (Frequency Selector)

    The automatic switch-OFF does not relieve the operator of his responsibility to turn OFF the transmitter when not in use ! The micron 4 can be reactivate by means of the "On/Horn“ pushbutton (refer to illustration on page 8, pos. Â).
  • Page 10: Battery And Battery Charger

    – Use the charger at room temperature (20 °C or 68 °F) and protect it from extreme heat (direct sun). Radio System HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY 2000-08-15 Information and specifications subject to change without notice.
  • Page 11: Special Operating Modes (Optional)

    Turn the rotary switch (pos. Á) on transmitter 1 to the "Catch" position. Transmitter 1 now has sole access to all crane functions. Radio System HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY Information and specifications subject to change without notice. 2000-08-15...
  • Page 12 OFF from the supply voltage (master switch) and the crane control system reactivated as described above. – A lamp on the crane-end of the control system (optional) indicates whether the receiver is engaged. Radio System HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY 2000-08-15 Information and specifications subject to change without notice.
  • Page 13: Pitch - Catch - Tandem Mode

    Turn the rotary switch (pos. Á) on transmitter 1 to the position "A" or "B" or "A+B" or "B+A". Transmitter 1 now has sole access to all crane functions. Radio System HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY Information and specifications subject to change without notice. 2000-08-15...
  • Page 14 – A lamp on the crane-end of the radio control system (optional) indicates whether the receiver is engaged. Radio System HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY 2000-08-15 Information and specifications subject to change without notice.
  • Page 15: Fault Correction

    − Fully recharge battery. − Ensure that recharging − Battery defective. process runs correctly. − Check transmitter functions using a fully charged or replacement battery. Radio System HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY Information and specifications subject to change without notice. 2000-08-15...
  • Page 16: Maintenance

    HBC-radiomatic GmbH – Customer Services/Repair Service – Tel.: +49 ( 0 ) 79 51 – 3 93 - 816 Radio System HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY 2000-08-15 Information and specifications subject to change without notice.
  • Page 17: Technical Data

    500 g ( 1.0 lb. ) System of protection IP 55 ( Nema 4 ) Accessories The following accessories are available for the transmitter micron 4 and must be ordered separately : Description Order No. Belt clip for micron transmitter ( standard accessory )
  • Page 18: Dimensions And Operator Controls Of Micron 4

    Operating Instructions Radio Transmitter micron 4 Industrial Page 18 / 18 BE-MICR4_I-V2-2.DOC [ Word 97 ] FL Dimensions and Operator Controls of micron 4 À STOP Á micron made by HBC Â 31.394 Ã Ä 50 mm ( 2.0 " ) 50 mm ( 2.0 "...

Table of Contents

Save PDF