ASSEMBLY
UNPACK
CARTON
& INSTALL
HANDLE
(See Fig. 2)
I&
CAUTION: Becarefulofexposedstaples
when handling or disposing of cartoning
material.
IMPORTANT:
WHEN UNPACKING AND ASSEMBLING
TILLER, BE CAREFUL
NOT TO STRETCH
OR KINK
CABLE(S).
•
Cut cable ties securing handles.
•
Slowlylitt handleassembly up, routecable(s) as sbown
and align handle holes with handle panel hole and slot.
•
Loosely assemble hardware as shown. Be sure the
shorter (3/4" long) hex bolt isassembled in lower hole of
handle. Repeatforoppositeside.
Tightenallhardware
securely.
•
Cut cable ties securing tiller to skid and remove tiller
from skid.
•
Remove screws securing depth stake to skid and
discard the screws.
LOCK
NUT
WASHER
TILLER
HANDLE
HANDLE
PANEL
HEXBOLT
_16-18X1"
HEXBOLT
WASHER
_1_18X_4"
TILLER
HANE
HANDLE
PANEL
BOLTS
INSTALL
DEPTH
STAKE ASSEMBLY
•
Loosen nut "A".
Insert stake support between engine bracket halves with
stake spring down.
•
Bolt stake support to engine brackets with bolts, lock
washers and nuts. Tighten securely. Tighten nut =A".
Depth stake must move freely. If it does not, loosen
support bolt.
\
ENGINE
BRACKET
NUT "A"
DEPTH
STAKE
BOLT
STAKE
SPRING
HEX BOLTS,
LOCK WASHERS,
AND HEX NUTS
FIG. 3
HANDLE
HEIGHT
•
Handle height may be adjusted to better suit operator.
(Bee "HANDLE HEIGHT" in the Service and Adjust-
ments section of this manual).
TILLING
WIDTH
•
Tilling width may be adjusted to better handle your tilling
conditions (See WINE ARRANGEMENT" inthe Service
and Adjustments section of this manual).
TINE
OPERATION
•
Check tine operation before first use.
(See "TINE
OPERATION CHECK" in the Service and Adjustments
section of this manual).
RG. 2
5