ASSEMBLY
•
First connect RED battery cable to positive (+) ter-
minal with hex bolt and keps nut as shown, Tighten
securely.
•
Connect BLACK grounding cable to negative (-) ter-
minal with remaining hex bolt and keps nut. Tighten
securely.
•
Replace battery cover,
Open battery cover for:
•
Inspection for secure connections (to tighten hard-
ware).
•
Inspection for corrosion.
•
Testing battery.
•
Jumping (if required),
•
Periodic charging,
BATTERY
COVER
DISCARD TERMINAL
PROTECTIVE CAPS _'L
HEX BOLT
KEPS
NUT
NEGATIVE
CABLE (BLACK)
POSITIVE CABLE
(RED)
FIG. 2
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
•
Remove adjustment knob and flat washer securing
seat to cardboard packing and set aside for assembly
of seat to tractor.
•
Pivot seat upward and remove from the cardboard pack-
ing. Remove the cardboard packing and discard.
•
Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan.
•
Push down on seat to engage shoulder bolt in slot and
pull seat towards rear of tractor,
•
Pivot seat and pan forward and assemble adjustment
knob and flat washer loosely. Do not tighten.
•
Lower seat into operating position and sit on seat,
•
Slide seat until a comfortable
position is reached
which allows you to press clutch/brake pedal all the
way down,
•
Get off seat without moving its adjusted position,
•
Raise seat and tighten adjustment knob securely,
SEAT PAN
SHOULDER BOLT
FLAT WASHER
ADJUSTMENT KNOB
FIG. 3
NOTE: You may now roll or drive your tractor off the skid,
Follow the appropriate instruction below to remove the
tractor from the skid,
_WARNING:
Before starting, read, understand and follow
all instructions in the Operation section of this manual, Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other people and objects.
TO ROLL TRACTOR
OFF SKID
(See Op-
eration section for location and function
of
controls)
•
Press lift lever plunger and raise attachment lift lever
to its highest position,
•
Release parking brake by depressing clutch/brake
pedal,
•
Place freewheel control in "transmission disengaged
position" (See "TO TRANSPORT" in the Operation
section of this manual),
•
Roll tractor forward off skid.
•
Remove banding holding the deflector shield up against
tractor,
TO DRIVE
TRACTOR
OFF SKID
(See
Op-
eration
section for location
and function
of
controls)
,_WARNING:
Before starting, read, understand and follow
all instructions in the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other people and objects,
•
Be sure all the above assembly steps have been com-
pleted.
•
Check engine oil level and fill fuel tank with gasoline,
•
Place freewheel control in "transmission engaged"
position (see "TO TRANSPORT" in Operation section
of this manual),