Environmental Considerations; Requirements For All Installations - United Screens Crystal Screens T-OLED User Manual

Table of Contents

ENVIRONMENTAL CONSIDERATIONS

•

The Crystal Screens is intended for indoor use only.

•

Systems should only be installed in an environment where the temperature and humidity are kept within the proper use range.

See the Environmental Specifications on page 19.

•

Crystal Screens displays are not designed to be sunlight readable.

•

Do not locate the displays in direct sunlight or where the Display Glass will be exposed to ultraviolet (UV) light.

•

The stele foot carrying the electronics should not be located near heat sources or in an environment where there is less than

20 mm of free space on all sides. Note that the Display Glass and the Display Chassis do not rise in temperature much above

ambient during operation.

•

For best use of the display transparency, make certain there is adequate illumination in the space behind the screen so that

items of interest can be viewed optimally through the display. We recommend you experiment with the level and orientation

of the illumination.

INSTALLATION DISCLAIMER

Proper installation of the display is the responsibility of the end customer. Failure to follow the safety and installation instructions

in this manual or Content Developer's Guide, or any installation of the display in a manner not described in this manual or Content

Developer's Guide, may result in damage to the system or unsafe conditions, for which the renter will be made responsible for.

Make sure the surface or structure where the display is to be mounted is capable of supporting the weight of the display or displays

to be used. Consult the „Specifications" section on page 19 for weights and measures. If the display is to be attached to a surface or

structure, use the four M8 mounting points in the Stele foot as the primary attachment point. No fewer than two of mounting holes

should be used in any installation. Make sure the Display Glass maintains a neutral position and is not loaded in any way. The front

Display Glass surfaces should be mounted straight and plumb, i.e. perpendicular to the horizontal in all axes.

For mounting a Crystal Screens, the leveling feet must be removed. For this purpose, please lay the column carefully on the floor

by means of two persons so that the pedestal foot is vertical.

upholstery of the upper part of the column/display chassis. The levelling feet can then be safely removed.

The ventilation openings in the Stele foot are a part of the thermal management system and should never be covered or have any

solid surface be located closer than what is defined in the figure below.

20mm

Attention:

please ensure that foam/foam parts are provided for the

20mm

Table of Contents