NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit http://www.horizonhobby.com and click on the support tab for this product. MEANING OF SPECIAL LANGUAGE The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product: WARNING: Procedures, which if not properly followed, create the probability of property damage, collateral damage, and serious injury OR create a high probability of superficial injury.
Water-Resistant Boat with Waterproof Electronics Your new Horizon Hobby boat has been designed and Metal parts, including the bearings, pins, screws and nuts, built with a combination of waterproof and water-resistant propeller, rudder, rudder mounts, prop struts, as well as components to allow you to operate the product in calm, the contacts in the electrical cables, will be susceptible fresh water conditions.
Catch Cup Use the catch cup to push floating objects in the water. To attach the catch cup to the boat, use a #1 Phillips screwdriver. NOTICE: When running the boat without the catch cup, do not reinstall the catch cup screw as it can scratch or rip swimming pool tiles or liners.
Charging the Battery Charging Warnings NOTICE: Charge only batteries that are cool to the CAUTION: All instructions and warnings must touch and are not damaged. Inspect the battery to be followed exactly. Mishandling of Li-Ion-Fe make sure it is not damaged e.g., swollen, bent, broken batteries can result in a fire, personal injury and/or or punctured.
Getting Started 1. Connect the battery to the ESC. 2. Power on the ESC switch. 3. Power on the transmitter. Control Check IMPORTANT: Perform a control check at the beginning of each boating session, after repair or after installation of a new battery. Ensure that the battery is fully charged.
Boating Tips Never operate your boat in less than 3 inches (7.6 cm) of water. This boat is intended for use in pools or small ponds but can be used in any body of water. CAUTION: Running your boat in shallow water increases the chance of debris entering the jet • Follow Self-Righting instructions if your boat flips.
• Remove the hatch before storing your boat. car. Doing so can damage the boat. • Repair any damage or wear to the boat. • Lubricate the driveshaft using ProBoat Marine Grease (DYNE4200). • Make note of lessons learned from the trimming of your boat, including water and wind conditions.
Drivetrain Lubrication which can cause water-flow restriction through the jet pump. It will not damage the drive system, but it may Always replace the drivetrain parts when they are decrease water flow through the jet pump, or attract damaged or show visible wear or injury and damage debris that will to stick to the grease.
Troubleshooting Guide Problem Possible Cause Solution Remove motor and apply penetrating oil to both ends of the motor. Rotate the motor shaft by hand Wet motor causes bushings to seize Boat will not respond to break the corrosive bond between the motor to throttle but responds shaft and the bushings to other controls...
Limited Warranty distributor or Horizon directly. This will enable Horizon to better answer your questions and service you in the event that you may need any assistance. For questions or assistance, What this Warranty Covers please visit our website at www.horizonhobby.com, submit a Horizon Hobby, LLC, (Horizon) warrants to the original Product Support Inquiry, or call the toll free telephone number purchaser that the product purchased (the “Product”) will be...
Warranty and Service Contact Information Country of Horizon Hobby Contact Information Address Purchase Horizon Service Center servicecenter.horizonhobby. (Repairs and Repair Requests) com/RequestForm/ productsupport@ United States of 4105 Fieldstone Rd Horizon Product Support horizonhobby.com America Champaign, Illinois, 61822 USA (Product Technical Assistance) 877-504-0233 websales@horizonhobby.com Sales...
Part # English Deutsch Français Italiano Start Up Tool Set: Set d’outils de DYNT0502 Anfänger-Werkzeugsatz Set attrezzi Proboat démarrage Clear Flex Marine Tape Transparentes, flexibles Adhésif Marin Nastro marino flessibile DYNM0102 (18M) Marine Tape (18 m) transparent flexible (18M) trasparente (18 m.)