Advertisement
Advertisement
Summary of Contents for Saltmate RP20
-
Page 1: Operating Manual
Operating Manual Auto-Clean, Standard and Pool Light Models... -
Page 2: Table Of Contents
We are certain you will enjoy the hassle free pool maintenance it will provide you with, hopefully giving you and your family more time to enjoy your pool. To ensure that you get the best results from your Saltmate chlorinator, please take the time to read through this operating manual. -
Page 3: Know Your Saltmate
Know Your Saltmate DELUXE AUTO-CLEAN CHLORINATOR (Includes RP20, RP30 & RP40) Cell switch ON | OFF Chlorine output Circuit breaker control Chlorine output /salt indicator 24hr Time Clock No water flow Pump switch indicator AUTO | OFF | MANUAL Cell lead junction box... -
Page 4: Installation Instructions
Plug the 3-pin power plug of your Saltmate into a suitable 240 volt A.C power supply. Plug the 3-pin power plug of your filter pump into the 240 volt A.C power point on the underside of your Saltmate power pack. -
Page 5: Chemical Maintenance
Pool chemistry should be tested at least once a week during summer months. Salt Level 4000ppm - 6000ppm by weight with 5000ppm being ideal (never below 4000ppm). All Saltmate models are over-salt protected and can run with levels higher than 6000ppm (ie: sea water) Free Chlorine 1.5ppm - 3.0ppm depending on the time of day, and period of time since the chlorinator has... -
Page 6: Operating Your Saltmate
It is recommended that your Saltmate is run for a few hours in the evening and a few hours in the morning. Super chlorination can be achieved by running your Saltmate overnight. This practice is recommended about once per fortnight during summer. - Page 7 LOOKING AFTER YOUR SALTMATE POWER PACK Do not carry out any maintenance or repair work other than that shown in this operating manual or advised by Saltmate, and only use parts recommended by Saltmate. If you do not it could invalidate your warranty.
- Page 8 CLEANING THE CELL Your Saltmate cell operates only efficiently when it is clean. To check your cell for cleanliness, disconnect the mains power supply, unscrew the nut at the top of the cell housing and remove the cell electrode.
-
Page 9: Troubleshooting
• Is the circuit breaker set? Push back in if popped out. • Is the pump plugged into the bottom of your Saltmate? Plug pump into power pack. • Is the cell clean? Clean cell. THE FREE CHLORINE RESIDUAL IN POOL IS LOW •... -
Page 10: Warranty
- The Electrolytic Cell (2 year conditional warranty plus 36 month pro rata at RRP) 3. Have you correctly tested your pool water for salt level? Your nearest pool shop should be able to do this test for you - Ideal range for your Saltmate is 5000 ppm- 6000 ppm. Never below 4000 ppm. - Page 11 Saltmate product, a Service Agent or Saltmate direct. Saltmate warrant the original purchaser of the Saltmate Power Pack for a period of 24 months from the DATE OF PURCHASE. This warranty only applies to failure caused by faulty manufacture or materials.
-
Page 12: Saltmate Contact Details
Manufactured by: ABN 77 115 408 010 HEAD OFFICE Lakeside Industrial Village 3 Mount Erin Rd Campbelltown NSW 2560 Australia T (02) 4625 3107 F (02) 4627 3194 E support@saltmate.com.au W www.saltmate.com.au...