2004-8-31
1. Press
key two times, the CTCSS code number will flash.
2. Press
key to select your desired main channel.
3. Press
key to confirm the selection.
Listen Or Speak To Your Correspondent
You cannot speak and listen to your correspondent at the same time. While you are
speaking, you cannot hear your correspondent.
To listen to your correspondent:
1. Make sure the
2. When your correspondent starts to speak.
3. You can adjust the speaker volume by pressing
number are shown according to the setting.
To speak to your correspondent:
1. Press and hold the
2. When you finish speaking, release the
Call Your Correspondent
Press the
key, the call tone will appears. The T-9701 of your
correspondent will beep , depending on the call alert setting.
Lock/Unlock Keys
After you have pressed and hold the
keys will not function.
To unlock the keys, press the
Monitor Mode
Your
has an Automatic Squelch Circuit to turn off the speaker when there is no
T-9701
receiving message. However, the circuit will reduce the reception ability if the
receiving message signal is weak. It is advised to deactivate the circuit if you want to
monitor the weak signal.
To deactivate the Automatic Squelch Circuit (monitor mode):
1. Press and hold the
2. You will hear noise. This is normal because the circuit will not turn off the
speaker even the noise is large.
To activate the Automatic Squelch Circuit again:
1. Press and hold the
Search The Main Channel and CTCSS code
This function enables you to find a main channel used by other people.
T-9701 USER MANUAL
key is not pressed.
key while you speak. The LED will light.
key.
key again. The icon
key until the monitor function enabled .
key until the monitor function will disable.
or
key, the icon
appears. The
will disappear.
Page: 8
keys, volume digital
Need help?
Do you have a question about the T-9701 and is the answer not in the manual?