Setting Osd Parameters - Huawei IPC6221-VRZ-SP Configuration Manual

IPC6221-VRZ-SP
Configuration Guide
Table 3-5 GENETEC settings
Parameter
To Enable GENETEC
Parameters
To Change the
GENETEC Password
To Enable the Keep-
Alive Function of
GENETEC Media
Streams
----End

3.3 Setting OSD Parameters

By setting on screen display (OSD) parameters, you can determine whether to display a text
on the screen or what text is displayed.
Procedure
Step 1 Choose Settings > Channel Configuration > OSD Parameter.
The page for OSD Parameters is displayed, as shown in
Issue 02 (2016-04-06)
Description
Select Enable GENETEC in Second Protocol Type.
NOTE
Change the GENETEC password to ensure security.
When the IPC uses the GENETEC protocol to connect to the video
surveillance platform, you must enter this password. Otherwise, the
connection cannot be set up. If platform authentication fails for
consecutively 10 times, the IPC is locked for 5 minutes. After you
change the password, keep the changed password safe.
1. In the Second Protocol Password management area, enter
passwords in the Old password, New password, and
Confirm password fields.
NOTE
The default user name is admin, and the default password is
HuaWei123.
To improve security, the password must consist of 8 to 20 characters
and contain at least two types of the following: uppercase,
lowercase, digits, and special characters.
2. Click Save.
Select Enable in the Media stream keep-alive switch area.
With the keep-alive function enabled for GENETEC media
streams, the IPC stops sending media streams if it does not
receive keep-alive packets sent by the video surveillance
platform within a specified period (60s by default).
If the video surveillance platform supports the keep-alive
function, you are advised to select Enable.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Setting Basic Parameters
Figure 3-6.
18