Related Manuals for Security Tronix ST-CCTV-VBAC
Summary of Contents for Security Tronix ST-CCTV-VBAC
- Page 1 INSTALLATION MANUAL© ST-CCTV-VBAC 1 Channel UTP Active Video Balun Transceiver Copyright North American Cable Equipment, Inc. v2.0 10/26/10...
-
Page 2: Package Contents
Unshielded Twisted Pair (UTP) cable. The ST-CCTV-VBAC-TX video transmitter converts an unbalanced video signal to a balanced signal transmitted over UTP. The ST-CCTV-VBAC-RX video receiver then converts the balanced video signal to an unbalanced signal for display on the device. -
Page 3: Installation And Operation
Connect the video source (e.g., security camera) to the ST-CCTV-VBAC-TX’s BNC port using coaxial cable with BNC connectors. b. Connect two wires from the UTP cable to the ST-CCTV-VBAC-TX’s wire block. Make note which color wire is connected to the wire block’s polarity. You will need to ensure the same wires and polarities are connected to the ST-CCTV-VBAC-RX’s wire block. -
Page 4: Troubleshooting
Connect a coaxial cable with BNC connectors between the ST-CCTV-VBAC-RX’s BNC port and the receiving device (e.g., display, DVR recorder). e. Connect an ST-PS12VDC1A 12V DC power supply to the ST-CCTV-VBAC-TX and another ST-PS12VDC1A power supply to the ST-CCTV-VBAC-RX. Connect each supply to an AC outlet. - Page 5 If the image is too bright the received signal may be too strong and require adjustment using the ST-CCTV-VBAC-RX’s Brightness Control and Sharpness Control. It may also be necessary to adjust the ST-CCTV-VBAC-TX’s gain control.