(There is no need for the wall power supply for vehicle use.) Step 2 Insert the cable attached to the phone cradle into the port labeled “VDC” located on the back of the 5BARz unit. Place the back of the 5BARz unit close to the windshield, hiding the cable whenever possible.
Note: The 12-Volt source that is providing power may not power off when you turn your car off. If the power to the 5BARz is on when the vehicle is turned off, unplug or switch off the 5BARz when leaving the vehicle – continuous operation without the engine running will drain the battery after some period of time (typically one day or more.)
Step 2 Insert the cable attached to the phone cradle into the port labeled “VDC” located on the back of the 5BARz. Place the phone cradle as far apart from the 5BARz as the cable will stretch for optimal performance.
Page 4
There must be a signal in the area for 5BARz to boost. Areas where there is no signal can not be helped with the 5BARz product. The 5BARz Road Warrior includes a USB connect port on the side of the phone cradle enabling you to power your phone while using the 5BARz.
Only accessories authorized by Cellynx Group, Inc. are approved for use with the 5BARz™ Road Warrior cellular signal booster. Modifications to the original equipment, or use of accessories that are not authorized by CelLynx, Inc. for use with the 5BARz™ Road Warrior, could void the user’s authority to operate the equipment.
Page 6
This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device. The 5BARz™ Road Warrior has internal gain control that ensures that the output power will not exceed the requirements as specified in the paragraph above.
Page 7
Maximum Allowed Antenna Gains Band Operating Channel Nominal Max Frequency Band Operational Gain Cellular 869 – 894 MHz 9.6 dBi Downlink Cellular Uplink 824 – 849 MHz 7.8 dBi PCS Downlink 1930 – 1990 MHz 7.9 dBi PCS Uplink 1850 –...