To create a new subnet group for LAN Devices:
1. Enter the Group name and the group name must be unique
2. Select the intended application of the new subnet group
3. Enter the corresponding IP and DHCP address
4. Passthrough MAC Address only needs to be entered in passthrough mode for the
specific device that needs to share the WAN IP address
5. You can define the IP address of the router device within the subnet in Route To
LAN IP Address for automatic routing rules to direct traffics to it; If the routing
requires a different subnet set, you can define it in Routing Subnet
6. If Secondary IP Address is empty, it will be calculated as one address less than
the last address of the defined subnet for the dhcp server.
Note: For Passthrough mode to correctly route the traffic, you need to reboot the
gateway
ND
2
LAN INTERFACE
To configure a secondary IP address, tick the checkbox
as shown here.
46