Table of Contents
Advertisement
Step 2: Set the WPS AP Mode. Configured is used when the NexusLink 5700.
will assign security settings to clients. Unconfigured is used when an external
client assigns security settings to the NexusLink 5700.
NOTES: Your client may or may not have the ability to provide security settings to
the NexusLink 5700. If it does not, then you must set the WPS AP mode to
Configured. Consult the device documentation to check its capabilities.
In addition, using Windows Vista, you can add an external registrar using
the StartAddER button
instructions).
II. NETWORK AUTHENTICATION
Step 3: Select Open, WPA-PSK, WPA2-PSK, or Mixed WPA2/WPA-PSK network
authentication mode from the Manual Setup AP section of the Wireless
Security screen. The example below shows WPA2-PSK mode.
Step 4: For the Pre-Shared Key (PSK) modes, enter a WPA Pre-Shared Key. You
(Appendix E - WPS OPERATION
23
has detailed
Advertisement
Table of Contents
