Advertisement

Quick Links

R380 Series Reader
User Manual

Document History

Description
Aug 2017 Revision 1

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this equipment. (Example - use
only shielded interface cables when connecting to computer or peripheral devices).
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the R380 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for ASIS Technologies R380 Series

  • Page 1: Document History

    R380 Series Reader User Manual Document History Description Aug 2017 Revision 1 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
  • Page 2: Table Of Contents

    Product Electrical Specification ..................13 R380 Series NFC Reader Overview The R380 Series Reader is a weather proof, high heat ABS NFC card reader. The R380 Series NFC reader can read a wide range of contactless smart card covering single size UID card to double size UID card.
  • Page 3: Reader Wiring And Color Code

    Reader Wiring and Color Code Terminal Point Description Recommended Cable Label Color Dev+ RS485+ Blue Dev- RS485- Grey +12VDC DC Ground Black Wiegand Data 0 Green Wiegand Data 1 White Red LED Brown Green LED Orange Buzzer Yellow Hold Purple Table 2 Wiring and Cable Color code 1.3 DIP Switch Setting (See table 3,4 for detail) Function...
  • Page 4: Dimension

    Reader 5 ~ 8 address Function Refer to (RS485) above table Address Table 4 RS485 Readers Address Dip Switch Setting Dimension Reader Module Dimension 76.00mm. 21.00mm. WebENTRA FRONT SIDE...
  • Page 5: Installation And Mounting Instruction

    Installation And Mounting Instruction Remove Bottom Screw Ply open the front cover using flat head screw driver remove the front of the unit. Remove the front of unit Mark out reader base (reader wire pigtail) and (wall mounting hole) drill hole on the wall for mounting reader.
  • Page 6: Operation Guide

    Reinsert reader front to base by set the bottom. Align reader pigtail cable accordingly. Push to front top to snap into the base. Tighten bottom screw Operation Guide Keeping the card in parallel to the R380 reader a maximum read range can be obtained.
  • Page 7: R380 Lcd Screen Message

    R380 LCD screen message Reader Ready Screen Reader Comm Fail Access Granted Card Flash Access Denied...
  • Page 8 Access Granted Card Invalid Card Read Comm Fail Fire...
  • Page 9 DOTL Door Force Open Pre Alarm Box Tamper...
  • Page 10 Reader Tamper Always Lock Always Unlock...
  • Page 11 Disarm Pin Mode Scrambled Keypad...
  • Page 12: Package List - R380 Reader

    Package List – R380 Reader Item Description: Complete with snap on cover. 1 x Mounting cover security screw [M3], 1 x security screw driver, and this document. Radio Frequency Interference Devices generate RF noise that may interfere with the reception of the signal from the access card.
  • Page 13: Product Electrical Specification

    Product Electrical Specification Power Supply (Recommend) Regulated linear power supply, +12VDC, 300mA Operating Voltage Range +9VDC - + 24VDC Operating Current at +12VDC 85mA (average) –250mA (peak) 150meters (500feet) (base on Belden 9538 24AWG 0.6mm, 8 core cable Maximum Cable Distance foilshield) (for wiegand interface) (base on Belden 9534 24 AWG 0.6mm, 4 core cable...

Table of Contents