Table of Contents
Advertisement
34 Compact Disc Autochanger Features and Operation (Optional)
NOTE!
1. Compressor
function
is
only
applicable in CD modes.
2. The compressor "effect" will vary
depending on the type of recording
you are listening to. Some recordings
will demonstrate dramatic changes
while others will display little or no
change.
Scan
Press the Scan (SeN) switch to search for your
favorite track. The indicator light
above
the scan
switch will illuminate indicating the player is in
• scan mode. This function will play the first ten
seconds of
every
track. When the changer
reaches the end of the current disc it will
continue on to the next available disc. To stop
scanning, press the scan (SeN) switch again.
The indicator light will extinguish.
NOTE!
If you drive over a severe bump the CD
(player may skip, particularly at low
!temperature. Play will resume at the
same point on the disc automatically.
This skip will not damage the disc.
Compact Disc Player Precautions
If the car is parked for a long time in the sun
during summer or in a cold location during
winter the temperature inside the car will reach
extre~e
levels. As the unit may not function
properly in such a case, use it only after the
ambient temperature has returned to normal.
NOTE!
Should the temperature in the car reach
an extreme level, hot or cold, the eD
player will stop operating to protect the
laser diode.
An out-of-temperature
situation will be indicated by the
" III
","Ale","
nn
","TRACK",disc
number and
trac~mber
indicators
flashing and the "PLAY" indicator
extinguished. On the autochanger, disc
indicators 1,3,5 and 2,4,6 will flash
alternately. If this happens, allow the CD
player to return to normal temperature
before using.
Care of Discs
1. When holding discs, do not touch their
signal surfaces. Hold by the edges, or by
one edge and the center hole.
-
---
2. Do not affix gummed labels or tape to the
NO
label surfaces. Also, do not scratch or
damage the label.
3. Discs rotate at high speed inside the
player. Do not use damaged (cracked or
warped) discs.
4. The presence of fingerprints or smudges
on the surface of the disc will not directly
affect the recorded signals but, depending
on the degree of contamination, the
brightness of the light reflected from the
signal surfaces may be reduced, causing
degradation of sound quality. Always keep
your discs clean by wiping them gently with
a soft cloth from the inner edge toward the
outer periphery.
~
\ !
Advertisement
Table of Contents
