Table of Contents
Advertisement
LOWER SHOULDER STRAP
CLAMP
Spacer Tabs
Spacer Tabs
positioned for use
on 1" diameter
1.
Place the upper shoulder strap clamp
over the upper tube above the handlebar.
2.
Position the lower shoulder strap clamp
under the upper tube and align the upper
and lower clamp screw holes
spacer tabs between upper and lower
clamps if necessary to secure clamp, i.e.
for 1" diameter upper tube).
Upper Shoulder
Strap Clamp
POWERHEAD
END
ATTACHMENT
Lower Shoulder
END
Strap Clamp
Screws
KNOW YOUR BRUSHCUTTER ATTACHMENT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
BRUSHCUTTER ATTACHMENT. Compare the illustrations with your unit to familiarize yourself
with the location of various controls and adjustments. Save this manual for future reference.
Hanger
Blade Shield
BLADE
The BLADE is designed for cutting grass,
weeds, and brush up to 1/2 inch in diameter.
3.
Insert two screws into the screw holes.
4.
Secure shoulder strap clamp by tighten-
ing screws with the hex wrench.
5.
Try on shoulder strap and adjust for fit and
balance before starting the engine or begin-
ning a cutting operation.
6.
Insert your right arm and head through
the shoulder strap and allow it to rest on
your left shoulder. Make sure the danger
sign is on your back and the hook is to the
right side of your waist.
NOTE:
A one-half twist is built in the shoulder
strap to allow the strap to rest flat on the shoul-
der.
upper tube
7.
Adjust the strap, allowing the hook to be
about 6 inches below the waist.
8.
Fasten the strap hook to the upper clamp
and lift the tool to the operating position.
(use
Shoulder
Strap
Clamp
OPERATION
Tube
Gearbox
Blade
LOCKING LEVER
The LOCKING LEVER is used to prevent the
blade shaft from turning during blade replace-
ment.
5
Shoulder Strap
Locking Lever
Advertisement
Table of Contents
