RoboKaddy
Trouble Shooting
P R O B L E M
P O S S I B L E C A U S E
My RoboKaddy will not work.
Main battery flat.
Handset battery flat.
Main battery not connected.
Switching from remote
to manual.
My RoboKaddy stops on
Machine is out of range.
the course without my
command.
Batteries are running
very low.
My battery has failed and I
Have you disengaged
the wheels?
can't push my RoboKaddy.
My RoboKaddy will not go
Machine not stationary
in reverse.
The LED on the base
The thermal overload has
controller is displaying a
been tripped.
red light.
W H AT T O T RY
Fully charge main battery.
Check the LED in the centre
of the handset, if flashing
red when activated all is ok.
Try RoboKaddy in manual
mode. Check battery
connections.
Turn the machine off then on
with the rocker switch and
try again.
Move closer and try again.
Recharge main battery/
replace. Have the main
battery checked/replaced.
Check and follow section
on disengaging wheels in
Q and A.
The trolley must be stationary
and off or stop keys pressed
before you can select reverse.
Avoid the obstruction or
circumstance that has caused
this.The unit will re-set when
a safe working temperature
has been reached.
9
Trouble Shooting
P R O B L E M
P O S S I B L E C A U S E
The LED on the base
The current overload has
controller is flashing
been tripped.
red light.
The LED on the base
The main battery has
controller is displaying an
fallen to below the required
orange light
voltage to operate.
The LED on the base
The handle is communicating
controller is displaying a
correctly with the base
flashing orange light.
controller.
My trolley pulls to left or right
Trimmer function requires
on a flat surface.
adjustment.
Tracking is out of
adjustment.
Air tire models, tire soft
on one side
10
W H AT T O T RY
Avoid the obstruction or
circumstance that has
caused this. The unit will
re-set after a short while in
the idle position
If you are attempt more than
18 holes, this may sometimes
occur. If you have forgotten
to charge the battery, this
will occur. At any other time
speak with your service agent
or PowaKaddy for help.
No action needed.
See page 7 for trimmer
details.
See page 7 for tracking
instructions.
Ensure tires are both
between 20 -24 psi
(1.38 -1.65 bar).
Need help?
Do you have a question about the RoboKaddy and is the answer not in the manual?