About Radio Reception - Oregon Scientific RM328P Instruction Manual

To install the adapter:
1. Insert adapter into jack on the bottom of the unit.
2. Plug the adapter into the adapter socket.
Note: Making sure the voltage is correct, plug the other end of
the power adapter into a free wall socket.
Once the power adapter is in place, you can select to turn on the
projector for longer periods of time, such as throughout the night, by
sliding out the PROJECTION LIGHT ON - switch on the back of
the unit. To turn off the projector, slide the switch back.
Note that this switch can only be used with the power
adapter installed. For momentary projection, use the
[
HOW TO USE THE BACKLIGHT
Press [
for five seconds.

ABOUT RADIO RECEPTION

The RM328P is a radio frequency (RF) controlled clock. When
located within a 1500km radius of radio signal (DCF77) at Frankfurt,
Germany, the clock time will automatically synchronize with DCF77
].
] once. The back light will activate
time-signal transmission. The benefit of a RF controlled clock is that
highly-accurate time is maintained and manual adjustments to the
time and date are not be required.
(UK version within a 1500km radius of radio signal (MSF) from
Rugby, England)
When the batteries are first installed, the RM328P (RM328PU) will
automatically search for a radio signal.
When in search mode, the antenna icon [
process takes between two (2) and ten (10) minutes. After initial
search, short periodic reception-signal scans will commence several
times a day.
The antenna icon indicates the quality of reception.
- Unit has received radio signal.
- Clock is searching for radio signal but not yet
received. It is recommended that you reposition or
rotate the antenna.
- The display time has been manually set and is not
synchronized to the RF signal.
- Radio reception is disabled and no signal reception
will be initiated until it is enabled again.
No indicator
- When the antenna symbol blinks, a reception is going
on. A full reception takes approx. 2 to 10 minutes,
depending on the quality of the signal received.
The hourly scanning may take a few seconds only.
4
] will blink. This