Setup
Button
Status
All buttons
You tapped the
lit
touchpanel within the
last 10 seconds. If the
buttons remain lit after
10 seconds, the
keypad is not
registered to a hub.
All buttons
Registration mode
blinking
(you pressed and held
M
N)
*1
You can configure the keypad so
that its alarm mode buttons do not
light during normal operation. For
more information refer to the
User's Guide (page 12).
Setup overview
1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Registration
Required only if the keypad was
purchased separately (i.e., not as
part of a bundle).
3
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
4
Installation
Install the keypad in the desired
location.
8
For assistance, please visit www.panasonic.com/support
Registering the
keypad
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the keypad, it must
be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
Note:
R Before registering the keypad, make
sure the AC adaptors of the hub and
keypad are connected and each
device is powered.
Using registration buttons
1
Hub:
Press and hold M
DEVICEN until the LED indicator
blinks in green.
2
Keypad:
Press and hold M
buttons displayed on the
touchpanel start blinking.
R When registration is complete,
the hub sounds one long beep.
Note:
R To cancel the registration, press
M
N on the hub and on the
keypad.
R If registration fails, the hub sounds
several short beeps.
OTHER
N until the