Digital Monitoring Products 1122 Installation Manual

1122 WIRELESS PIR MOTION DETECTOR
Installation Guide
Figure 1: 1122 Wireless PIR
Motion Detector
DESCRIPTION
The 1122 Wireless PIR Motion
Detector uses passive infrared
technology to detect motion in a
wide angle lens pattern.
The 1122 also features an internal
case tamper, survey LED, and low
battery indicator.
Pet immunity is available for animals
up to 55 pounds and can be turned
on or off. Disarm/disable, pulse
count, and adjustable sensitivy are
also offered on the 1122.
Compatibility
All DMP 1100 Series Wireless
Receivers and burglary panels.
What is Included?
• One 1122 Wireless
PIR Motion Detector
• One 3V lithium
CR123A battery
1

PROGRAM THE PANEL

When programming the 1122 in the panel, refer to the panel
programming guide as needed.
In ZONE INFORMATION, enter the wireless ZONE number.
1.
2. Enter the ZONE NAME.
Select NT (Night) as the ZONE TYPE.
3.
4. Select the AREA.
At the NEXT ZONE prompt, select NO.
5.
6. Select YES when WIRELESS? displays.
Enter the eight-digit SERIAL# and press CMD.
7.
8. Enter the SUPRVSN TIME and press CMD.
9. Choose whether or not to enable DISARM DISABLE.
Note: Selecting YES allows the 1122 to be disabled for
Night and Exit type zones while the area is disarmed.
10. Choose either 2 or 4 for the PULSE COUNT.
Note: The pulse count is the number of pulse inputs
(trips) the 1122 needs to sense before going into alarm.
11. Choose either LOW or HIGH for the SENSITIVITY.
Note: Selecting LOW sensitivity may reduce false alarms
for installations in harsh environments.
12. Choose whether or not to enable PET IMMUNITY.
13. At the NEXT ZONE prompt, select YES if you are finished
programming the zone. Select NO if you would like to
access additional programming options.
2

INSTALL THE BATTERY

Use only a 3.0V lithium battery, DMP Model CR123A, or the
equivalent battery from a local retail outlet. Keep in mind, when
setting up a wireless system, program zones and connect the
receiver before installing batteries in the transmitters.
1. Remove the holding screw at the lower end of the 1122
case and gently lift off the cover.
2. Observing polarity, place the battery in the holder and
press into place. See Figure 2 for the battery location.
Tamper
Switch
PCB
Screw
Battery
Location
Figure 2: 1122 Housing and PCB
LT-1647 © 2017 Digital Monitoring Products, Inc.
Survey LED
17164