Table of Contents
Advertisement
This unit operates on 100-240V~ 50/60Hz. Do not attempt to operate the product on any other power source.
You could cause damage to the unit and void your warranty. Please be sure the power outlet you plug this
unit into is working and receives constant (un-switched) power.
Insert the power adapter into the DC IN Jack on the back of the unit, then plug other end into an AC wall outlet.
NOTE: The turntable has a protective cap over the Stylus Cartridge. Please make sure to remove the
protective cap before playing records. Do not dispose of the protective cap. You can use this to
protect the Stylus Cartridge during transporting the turntable.
1.
Release the Latch on both sides of the Turntable Cover and open the lid.
2.
Turn the unit on by turning the Power and Volume Knob. The red Power Indicator Light will show the
turntable is on.
3.
Place a record on the Turntable Platter and using the Speed Selector Switch, select your desired speed
(33 / 45 / 78 RPM).
NOTE: When playing a 45 RPM record, use the included 45 RPM Adapter.
4.
Open the Tone Arm Clip to release the Tone Arm and push the Lift Lever to lift the Tone Arm.
5.
Gently move the Tone Arm to the desired position over the record. The record will begin to spin as the
Tone Arm moves above the record.
6.
Pull the Lift Lever to slowly lower the Tone Arm onto the record and it will start to play.
7.
Rotate the Volume Knob to adjust to the desired output level.
8.
To turn off the turntable, turn the Power and Volume Knob until the red Power Indicator Light turns off.
NOTE: By default the Auto Stop Switch is in the ON position. This will automatically stop playing the
record when it is finished. When the Auto Stop Switch is in the OFF position, the record will not
automatically stop when finished.
1.
Insert a USB thumb drive into the USB Port or a SD card into the SD Card Port.
2.
Following the steps above for the turntable operation, place a record on the Turntable Platter, turn on the
turntable and release the tone arm. Move the Tone Arm to the desired position over the record and the
record will begin to spin
3.
Press and hold the Mode Button (RECORD Button) to start recording and you will hear 1 beep. This will
start to record and convert the music to digital MP3 files on the USB drive or SD Card.
4.
Pull the Lift Lever to slowly lower the Tone Arm onto the record to start playing and recording the music.
5.
To stop recording, press and hold the Mode Button (RECORD Button) and you will hear 2 beeps. You
can repeat this process to convert more songs to MP3.
NOTE: Please ensure the volume is turned up to hear the beeps to start and end recording.
6.
The converted music will be stored on the USB thumb drive or SD Card in a folder named RECORD0.
1.
Insert a USB thumb drive into the USB Port that contains MP3 music files.
2.
Turn the unit on by turning the Power and Volume Knob and press the Mode Button repeatedly to cycle
between Bluetooth, USB and SD Card functions. Once you reach the USB function, the music will start
to play automatically.
3.
Adjust the volume and use the Play/Pause, Skip Forward and Skip Backward buttons to control the
music.
4.
Repeat the above steps for SD Card playback.
POWER SUPPLY
TURNTABLE OPERATION
COVERTING RECORDS TO MP3
USB & SD CARD PLAYBACK
E-5
Advertisement
Table of Contents
