Hub36-Dc - Radio Systems HUB16-DC Technical Manual

For Assy:

HUB36-DC

Rev: 01/05
Product Key
Name
Mount
Channels
CAT-5 Pairs
Power Link
Connectors
Versions
General
Each of the 36 Hub channels consists of two 2-pin mini-Amp
input connector in parallel with an RJ-45 connector. Each
channel carries a stereo balanced audio pair, or balanced digital
audio signal. Custom length and configuration harness cables
may be factory ordered to interconnect the Hub to various
consoles, audio routers and engines or multi-channel Digital
Audio Workstations.
DC Power
If using any StudioHub+ "DClink" accessories, plug a
StudioHub +/- 15 volt power supply into the power supply
connector. Both Hub LED s will illuminate. Insert both power
jumpers only on only the circuits that utilize a powered
accessory (e.g. MatchJack, mic preamp, etc.).
Grounding Information
RJ-45 connector shields may be isolated from each other or
optionally connected to each other or to the hub chassis by
inserting jumper by each connector.
To use the hub as a common ground point, insert a jumper below
each RJ-45 that you want common to be in common with the
chassis ground. If you have a StudioHub+ 15V power supply
connected to the hub, to connect each RJ-45 to the power supply
shield, insert a jumper above each RJ-45. Insert JU-33 to
common the chassis ground and power-supply shield.
R3
Power Supply Ground
1/2 Amp
auto reset
fuse
RJ- 45
J3
J5
AES/L
1 +
8
2 -
7
6
3 S
5
Mini Amp
4
R 3
1 +
2
2 -
1
3 S
J1
Shield
Radio Systems, Inc.
(856) 467-8000
StudioHub+ Model HUB36-DC
Engineered for Console Harnesses
HUB36
Hub (3 R.U)
36
2 (pins - 1,2,3&6)
yes
Mini-amp & RJ-45
Full Hub
JU5 15v-
R1
15v+
JU3
1/2 Amp
auto reset
fuse
x 36
JU1
JU7
Hub Chassis Power Supply
Ground Shield
JU145
601 Heron Drive
•
Fax (856) 467-3044
•
+/-15V external power
supply main and loop-
thru jumpers
Logan Twp., New Jersey 08085
•
www.studiohub.com
•
Insert jumper above any
RJ-45 upper to connect
that channel s shield to
the common chassis
ground
Insert jumper below any
RJ-45 to connect that
channel s shield to the
common shield bus
Install both DC jumpers
to activate StudioHub+
DC-Link connection to
provide +/-15V DC to
any powered accessory
Upper and lower 2-pin
mini-amp connectors
wire to source gear audio
I/O via certain harness
cables
LED s indicate presence of
+/- 15V DC
6