Table of Contents
Advertisement
Front-Panel Controls
Control buttons (represented by icons) are located on the bottom right of the monitor.
Button
Quick View
Minus
Source
Plus
Auto Adjustment
OK
Menu
Power
NOTE:
To view an OSD menu simulator, visit the HP Customer Self Repair Services Media Library
at http://www.hp.com/go/sml.
Turning on the Monitor
1.
Press the power button on the front of the monitor to turn it on.
2.
Press the power button on the computer to turn it on.
CAUTION:
screen for a prolonged period of time.* To avoid burn-in image damage on the monitor screen, you
should always activate a screen saver application or turn off the monitor when it is not in use for a
prolonged period of time. Image retention is a condition that might occur on all LCD screens. Monitors
with a "burned-in image" are not covered under HP warranty.
* A prolonged period of time is 12 consecutive hours of non-use.
When the monitor is powered on, a Monitor Status message is displayed for five seconds and the
power source LED on the rear of the monitor is green. The message shows which input is the current
active signal, the status of the auto-switch source setting (On or Off), the default source signal, the
current preset display resolution, and the recommended preset display resolution.
Icon
Burn-in image damage might occur on monitors that display the same static image on
Description
Opens the OSD Quick View menu where you can select a viewing mode
which compliments or optimizes the content you are viewing.
Navigates down through the OSD menu and decreases adjustment levels.
Chooses the video input source from the computer.
Navigates up through the OSD menu and increases adjustment levels.
Press to automatically adjust the screen image.
NOTE:
This item can only be used with a VGA input signal.
Enters the selected option in the OSD.
Opens, selects, or exits the OSD menu.
NOTE:
Pressing the Menu button for 10 seconds will disable operation of the
remaining OSD buttons. Pressing it again for 10 seconds will re-enable
functionality.
Turns the monitor on or off. The Power button is located on the bottom-right of
the monitor.
NOTE:
Pressing the Power button for 10 seconds will disable operation of
the Power button. Pressing it again for 10 seconds will re-enable functionality.
Front-Panel Controls
9
Advertisement
Table of Contents
