Circuit Mode Functions; End Point Adjustment - Technicstar Ken User Manual

Circuit Mode contains the most commonly used programming features that you'll
likely be changing on the circuit. Circuit Mode programming is laid out in 3 levels
that are accessed in user's capability and the kind of race.
The Circuit Mode menu is accessible as shown below.
1. Press button at normal display
2. Press button for displaying Circuit Mode menu.
(Display automatically reverts back to Normal Mode if there is no activity in Cir-
cuit Mode for a period of 5 seconds).
End Point Adjustment (EPA)
End Point Adjustment, also referred to as travel adjust or travel volume, allows the
precise maximum servo throw in either direction to be independently adjusted. The
travel adjust range is from 0 - 150% (0 to 60
maximum right/left steering and forward/brake position independently. Remem-
ber, dual rate and brake trimmers work in unison with travel adjusts.
Note: Be sure that steering and throttle operation does not apply unreasonable
force to the servo horn. Unreasonable force applied to the servo horn may result in
damage to the servo and loss of control.
1. Press button until the cursor is at EPA.
2. Press button to display EPA screen.
3. Press / button until desired EPA value appears on steering left.
4. Press and
5. Press and
6. Press and
(To return to the default setting, press
onds)
7. Press button to return to the Circuit menu.
Circuit Mode
EPA
Response
Steering speed

Circuit Mode Functions

/ button until desired EPA value appears on steering right.
/ button until desired EPA value appears on throttle forward.
/ button until desired EPA value appears on throttle back.
o
servo travel). This is used to set the
, buttons simultaneously for 3 sec-
EPA
Steering
Throttle
left 100
forw 100
right 100
back 100
EPA