Related Manuals for Bodet BP30001
Summary of Contents for Bodet BP30001
- Page 1 MELODYS Indoor Melodys Instructions for installing and use BODET SA BP30001 49340 TREMENTINES Tél: +33 241 71 72 99 Fax: +33 2 41 71 72 01 www.bodet-time.com Check the product for shipping damage on reception for any reservations to the carrier.
-
Page 2: Table Of Contents
Index 1 - MECHANICAL INSTALLATION 2 - ELECTRICAL INSTALLATION 2.1 - Configuration Wireless DHF/Wired 2.2 - « Wireless DHF » mode installation 2.3 - « Wired mode » installation 3 - SETTING THE MELODIES 4 - TECHNICAL CHARACTERISTICS When proceeding to the installation, do not forget to select the triggering mode of the Melodys: «wireless DHF»... -
Page 3: Electrical Installation
2 - ELECTRICAL INSTALLATION 2.1 - Configuration Wireless DHF/Wired The DIP switch 2 is used to set DIP2 to position the wireless Melodys in off = wired version wired version. DIP2 to position on Warning : the operation is different = wireless version according to the mode being used: in “Wireless DHF”... - Page 4 Define the address of the DHF sounder using DIP switches 5 to 8 (see table below) and refer to the Sigma master clock manual. DHF circuit no Dip 5 Dip 6 Dip 7 Dip 8 Beware: in DHF version the DIP switch 2 must be in the ON position.
-
Page 5: Wired Mode » Installation
2.3 - « Wired mode » installation In accordance with the model, 100- 240VAC ±10% 50/60 Hz or 24 VDC, connect the appropriate power supply on the terminal strip (2). As the device is a class II device, there is no earth connection. The cable must be attached (point 4) in such a way as to place no stress on the connection terminals. - Page 6 Imperative : the equipment must be switched on only after fixing, and reinstalling of the front panel. FOperation of the sounder in « wired mode » : The sounder is controlled by any programmer. - The “~” LED indicates the presence of the power supply.
-
Page 7: Setting The Melodies
3 - SETTING THE MELODIES The Melodys sounder includes 16 melodies in the standard configuration. By default, melody number 16 is played. To access the sounder controls, unscrew the screw (3) under the sounder and remove the access flap by pulling it forwards. The “MEL”... -
Page 8: Technical Characteristics
4 - TECHNICAL CHARACTERISTICS The MELODYS sounder complies with electromagnetic compatibility directive 89/336/ EEC and R&TTE directive 1999/5/EEC. The MELODYS sounder are designed for a residential, commercial or industrial environment. They comply with the European standards : EMC Directive 2004/108/EEC and Low Voltage Directive 2006/95/ EEC, EN 60950: Safety of Information Processing Devices.