Configure Access To The Device; Select Access Channel - Go Net Systems GoBeam8000 Quick Configuration Manual

NOTE: For more information on the different type of radio interfaces your device contains
and the interface numbers for the access radio interfaces see the Radio Interfaces
table.
Example:
/configure ssid 3 name GO-WLS2 vlan 7 privacy-method wpa
type hidden
/configure privacy wpa ssid 3 passphrase 12345678 Management
key-mngmnt psk
/configure interface Dot11Radio 0 ssid 3 add
copy running-config startup-config
7.

Configure access to the device

The following steps configure the access to the device:
a. Disable access to the device using an unsecured Telnet protocol:
/configure ip telnet disable
b. Add a user with a password to access the device:
/configure username <username string> password <password string> privilege
{super | admin | viewer}
c. Set a hostname and prompt to be unique for each device:
/configure system hostname <prompt string>
d. Save the configuration: copy running-config startup-config
Example:
/configure ip telnet disable
/configure username Paul password GoNetSystems privilege super
/configure system hostname Gateway1
copy running-config startup-config
8.

Select Access Channel

The following steps are used to select and define the access radio channel:
a. Scan all access channels and gather data for channel selection
(A site survey takes approximately 10 minutes):
/configure sitesurvey start spectrum 2.4G auto-channel-selection { enable |
disable }
b. Display the results of the site survey:
show sitesurvey
c. Set the access radio channel based on the best grade identified by the site survey
(grade values for the adjacent channels are critical when selecting a channel):
/configure interface Dot11Radio <interface number>
channel <channel number>
d. Save the configuration: copy running-config startup-config
All contents are Copyright © 2013 Go Net Systems Ltd. All rights reserved.
GoBeam8000 Quick Configuration Guide
Document#
Page 4
UM000004 Rev. 1.0