Operation - Bad Backs QDOS TN Assembly And Use Manual

TABLE OF CONTENT
1. SAFETY AND WARNINGS
2. USAGE
3. SET UP AND INSTALLATION

4. OPERATION

5. MAINTENANCE AND DEFECTS
6. TECHNICAL DATA
7. PARTS
8. ASSEMBLY DIRECTIONS
9. DECLARATION OF CONFORMITY
1. SAFETY AND WARNINGS
This table complies with the prescribed safety regulations. Inappropriate use may cause damage to

persons and table.
Please read the operation manual prior to start using the table. It provides you with important

information about safety, use, installation and maintenance of the table, and thus protecting you
and your children and avoiding damage on the table.
Please guard this operation manual and pass it on to any future owner!

2. USAGE
The electromotive, height-adjustable tables are designed for workstations in dry work environments only

(0-40C; 20-90% relative humidity). The table height is infinitely adjustable, so that it can be set to the
most ergonomically suitable working level.
They have not been designed for other purposes than those included in this manual, e.g. they are not to

be used in areas of high humidity or dampness, nor for lifting people.
Any other use is at one's own risk!
Do not crawl, lie or move around under the table frame, and do not sit or stand on the table

frame.
CHILDREN should only use the table when supervised by adults.

Liability: The manufacturer accepts under no circumstances warranty claims or liability claims for

damages arising from improper use or handling of the table frame other than that described in this
operation manual.
3. SET UP AND INSTALLATION
When the table has been assembled (see assembly directions in CHAPTER 8) the adjustable feet are
installed so that the table is level and does not shift. Then the table is connected to the 100-240 VAC outlet
and the table is ready for use.
Make sure that no cables can get jammed.

Place the table in a safe distance from window frames, radiators, furniture etc. so that people do not get

stuck.
Do not place any objects above 55 cm underneath the table.

When moving the table after it has been assembled, the table top needs to be removed. The table

CANNOT be lifted by the tabletop.
4. OPERATION
UP/DOWN operation:
BOTH buttons must be
pressed SIMULTANE-
OUSLY.
2