Download Print this page

Bad Backs QDOS TN Assembly And Use Manual

Height adjustable electric desk frame

Advertisement

Quick Links

ELECTRIC HEIGHT ADJUSTABLE DESK
QDOS "TN" Height Adjustable Electric Desk Frame
DIRECTIONS FOR USE / ASSEMBLING
WARNING
Prior to installment, use and maintenance of the table frame, any installer and any user of the table must study
this assembly and operation manual carefully, so as to gain a complete understanding of its contents.
ConSet® - MODEL 501-29
(PAT. PENDING)
EN
WARNING: FAILURE TO COMPLY WITH OR OBSERVE ALL
ASSEMBLY, SAFETY AND OPERATION INSTRUCTIONS
AND WARNINGS REGARDING THE USE OF THIS
PRODUCT MAY RESULT IN SERIOUS BODILY INJURY.
IMPORTANT NOTES!
1
324250.4

Advertisement

loading

Summary of Contents for Bad Backs QDOS TN

  • Page 1 ELECTRIC HEIGHT ADJUSTABLE DESK QDOS "TN" Height Adjustable Electric Desk Frame ConSet® - MODEL 501-29 (PAT. PENDING) DIRECTIONS FOR USE / ASSEMBLING WARNING: FAILURE TO COMPLY WITH OR OBSERVE ALL WARNING ASSEMBLY, SAFETY AND OPERATION INSTRUCTIONS AND WARNINGS REGARDING THE USE OF THIS PRODUCT MAY RESULT IN SERIOUS BODILY INJURY.
  • Page 2: Operation

    TABLE OF CONTENT 1. SAFETY AND WARNINGS 2. USAGE 3. SET UP AND INSTALLATION 4. OPERATION 5. MAINTENANCE AND DEFECTS 6. TECHNICAL DATA 7. PARTS 8. ASSEMBLY DIRECTIONS 9. DECLARATION OF CONFORMITY SAFETY AND WARNINGS This table complies with the prescribed safety regulations. Inappropriate use may cause damage to ...
  • Page 3: Maintenance And Defects

    MAINTENANCE AND DEFECTS The table does not require any maintenance by usage as described in chapter 2 in the directions for use.  The table is only to be maintained with a wrung cloth.  In the event of the occurrence of jarring sounds during operation, STOP using the table and please ...
  • Page 4: Assembly Directions

    ASSEMBLY DIRECTIONS continued ….
  • Page 5 continued ….. Run the wire with red plug from the control panel through these holes and connect to the d) x 2 power supply. c) x 1 e) x 2 b) x 2 a) x 4 UP/DOWN operation: BOTH buttons must be All screws d) need to be tightened to obtain optimal stability.
  • Page 6 Industrivej 23 DK -6900 Skjern Denmark Tel: +45 9680 0080, Fax: +45 9680 0081 www.conset.com conset@conset.com Bad Backs 79 Overseas Drive Noble Park, VIC 3174 Australia T. (+61) 03 9020 2098 | F. (+61) 03 9020 2092 | E. sales@badbacks.com.au...