Advertisement
OPERATING INSTRUCTIONS
1. Confirm that the power switch on the inflator is in the "OFF" position.
2. Remove valve cap from stem.
3. Attach the universal connector from the inflator to the valve stem with the lever in the "UP" position. Press the lever down to lock
onto the valve stem.
4. Plug power cord into a 12V DC power outlet.
WARNING
!
For use with any 12V DC power outlet rated 15-Amps or higher. Do NOT use with older 8-Amp cigarette lighter receptacles.
5. Turn inflator on using the power switch and inflate to the manufacturer's recommended air pressure.
6. Once desired pressure is reached, turn power switch to "OFF" position.
7. Unplug the power cord from 12V DC power outlet.
8. Remove the universal connector from the tire valve.
TROUBLE SHOOTING
INFLATOR DOES NOT WORK WHEN SWITCHED TO "ON"
– Power cord may not be plugged in completely. Check the connection.
– Fuse may have blown. Check fuse in plug adaptor and replace if necessary.
UNIT IS RUNNING BUT TIRE IS NOT INFLATING
– Check that the universal connector is attached properly to valve stem.
– Check for tire leaks or damages to tire.
INFLATOR FEELS HOT
– Unit may have overheated. Shut the unit off and allow to cool for 20-25 minutes.
– NEVER use this inflator for more than 10 minutes continuously.
CONTACT INFORMATION
QUESTIONS/COMMENTS:
Bell Automotive® Products, Inc.
Attn: Customer Service
18940 N. Pima Road, Suite 200
Scottsdale, AZ 85255
www.bellautomotive.com
© 2011 Bell Automotive® Products, Inc.
Bell is a trademark of Bell Sports, Inc.
80137-8-08-1inst.ai
Advertisement
