Page 1
Ceiling Visualizer Trim Ring Installation Guide VZ-C6 Installations – Part 1 VZ-C12 / C32 Installations – Part 2 WolfVision Support 2055 Sugarloaf Circle, Suite 125 Duluth, GA 30097 (877) 873-WOLF support@wolfvision.us...
Page 2
Part 1: This guide is for the installation of the WolfVision VZ-C6 + Trim Ring into tiled ceilings. 1) Determine mounting location of camera using the WolfVision online A down rod may be used to ensure application in the Support Section proper installation of the unit above the suspended ceiling.
Page 3
4) Measure ¾ inch to rear of camera (narrow end). This mark will be the rear of your cutout. Note: This is the rear of the camera. 5) Using the mounting bracket as a template, align the center of one of the shorter sides with the rear cutout mark from step 4 and mark the outside of the bracket.
Page 4
7) The tile must be notched on the center of all four sides to allow for the screw posts. 8) Join the two halves of the Trim Ring together using the screws provided. Reinsert tile into ceiling.
Page 5
Part 2: This section is for the installation of the WolfVision VZ-C12 / C32 Visualizers + Trim Ring into tiled ceilings. 1) Determine mounting location of camera using the WolfVision online application in the Support Section of www.wolfvision.com. Note: All measurements are based on the mount being centered on the camera.
Page 6
3) Measure to the rear of the camera /₈’’ towards the rear of the camera. Note: The rear of the camera is the end toward the audience. 4) Measure 5 - ’’ to the left of the center mark. 5) The measurement in Step 4 will need to be transferred towards the rear of the tile to help with alignment.
Page 7
7) Using this outline, cut a hole in the ceiling tile. 8) The tile must be notched on the center of all four sides to allow for the screw posts. 9) Join the two halves of the Trim Ring together using the screws provided. 10) Reinsert into Ceiling.
Need help?
Do you have a question about the VZ-C6 and is the answer not in the manual?
Questions and answers