AJA Ki Pro Ultra Plus Installation And Operation Manual page 34

Warning: Input Error -
is supplied to the Ki Pro Ultra Plus or a link of a multi-link signal (dual link or
quad link) is missing; no recordings will be produced if this alarm appears.
Warning: Dropped Frames -
cannot keep up with the data rate required to make a recording or perform a
playback. If you see this prompt during recording, recordings will stop. If this
prompt appears, you might consider backing up your current recordings and
formatting the media. For playback, you might simply re-attempt playback.
Warning: Media Low -
remaining. Media must be switched out when it reaches 10% of capacity. With
10% of media remaining, the "Warning: Media Full" prompt will appear.
Warning: Media in Use -
operation is still taking place. Wait for the operation to finish and then try
again or press STOP.
Warning: Media Not Present -
and the user hits the slot button.
Warning: Media Unformatted -
recognize the file system on the SSD media or the media has never been
formatted.
Warning: Storage Removed -
hitting the SLOT button to properly unmount it. In the event this happens,
media immediately re-inserted into the Ki Pro Ultra Plus may show clips as
"N/A" and subsequent recordings may not be possible. To resolve this issue,
mount the media on an Apple computer under Mac OSX, then remove and
re-insert the media into your Ki Pro Ultra Plus. If the media does not read
properly, you will need to format it. Additionally, this alarm will lead to the
"Please Reboot" prompt.
Warning: Please Reboot -
slot button and the Ki Pro cannot continue operating and must be rebooted.
Warning: Backup and Reformat -
mounted by the Ki Pro Ultra Plus. As the prompt indicates, it is best to back up
the media by copying it to another hard drive or disk array and then reformat
the media. Some signs that the media is in a read-only state: even though
clips have been recorded to the media, "N/A" appears in the clip area of the
UI, "Loading" appears in the clip area of the UI but does not eventually load a
clip, or hitting the record button with all settings correctly configured for the
Ki Pro Ultra Plus does not result in a recording.
Warning: Rollover Not Empty -
contains existing recordings; the rollover feature requires empty media to
operate.
Warning: Rollover Media Unformatted -
formatted or recognized.
Warning: Name in Use -
parameters already exists on the media; this happens when take 999 is
reached and no more take numbers are available. Ki Pro Ultra Plus will refuse
to overwrite the clip; you will have to delete the clip or select a new name.
Warning: No Clip Name -
non-existent custom clip name.
Warning: Genlock Missing -
Genlock and you attempt to play a clip and no genlock is detected on the
selected input.
Warning: 2 Channel Format -
2.3 Audio Channels is eight, but the selected audio input only supports two
channels.
Ki Pro Ultra Plus File Based Recorder/Player v1.0r3
May appear if a format or frame rate that is not supported
Mayappear if media is under-performing and
Appears when the media only has 15% of capacity
May appear if you try to use media while another
May appear if media has been physically removed
May appear if Ki Pro Ultra Plus does not
Appears if the media is removed without first
Appears if media was removed without the use of the
May appear if the media has issues being
Appears if media for a rollover is not empty and
Appears if media for a rollover is not
Appears if the clip name specified in the naming
Appears if you attempt to record in gang mode using a
Appears if you choose "Input" or "Ref In" for 6.1
Appears if the number of channels selected in
34 www.aja.com