Inbeca Ecotouch User Manual page 3

• Optical fibre cromotherapy (F.O.)
Once optical fibre cromotherapy key is selected you will find 2 optional setting to establish the start-up /
shutdown and the colour functions. Scroll through the menu with selection keys.
- On/off: Selection for turning on and off optical fibre cromotherapy. To turn it off press and hold the "ac-
cept" key for 4 seconds
- Colour: Colour variation is a default setting. Press this key when the desired colour is lighting to set it
as a steady colour.
Light
The lamp is automatically switched on and off when the equipment is on / off. Select the corresponding
key to control it independently.
Timer
You may select timer with the second key of clock button, even if the steam bath is switched off.
Once selected, you set the time to be turn off with a minimum of 30 minutes. With the "+" and "-" keys you
may set intervals of 15 minutes range of variation.
Once you press the button, a steady light indicates that a programme is on going.
If you set the timer when the steam bath is off, timing will start once the equipment is turned on.
If you set the timer when the steam bath is on, timing will start immediately indicating the remaining time
to be turned off on the screen.
Once timer is enabled it will repeat every time you turn the steam bath on unless the option is disabled.
Temperature selection
The desired temperature value to be reached is showed on the right of the screen.
Press "ºC" key to change the room temperature value. Set the new desired value with the "+" and "-"
buttons. Press "ºC" key to exit and set the new selected temperature value.
If after 10 seconds "ºC" key is not pressed to exit temperature selection, you will be withdrawn with no
changes.
Fan
Ventilation is activated automatically once the equipment is turned on and off. It turns off after 20 minutes
shutdown, allowing water steam being built up in the room to eliminate.
You must not interfere with its proper functioning.
• Input and output panel:
In this panel we can see the state of the input and outputs. Access pressing Clock (7 and 8) keys during
some seconds. In the diagram it is indicated the Meaning of the details showed in the panel:
• Panel level probe
To control the level of water, the boiler has a probe with two levels at the same high. If one of them stop
working it is detected and start to work the other one.
To access to this panel press during some seconds both key ot the timer. This panel will show the state
of the level probe, for example if we see NIV 1:ok-Niv 2 X, it means level 1 works correctly and level 2
has been ingnored.
The system is designed to work in both levels, in the case that both probe are damaged we will have to
change the probe. Once it is changed we have to set it in the equipment, access to this panel and reset
with the key "Light", one we reseted the sreen will show Niv1:OK-Niv 2 OK".