Chevrolet 1973 Overhaul Manual page 171

6 -3 0 ENGINE
REM O VA L
nut. When bearing has been pulled from bore,
remove remover and installer tool and bearing
from puller screw (fig. 67).
5. Remove remaining bearings (except front and rear)
in the same manner. It will be necessary to index
pilot in camshaft rear bearing to remove the rear
intermediate bearing.
6. Assemble remover and installer tool on driver
handle and remove camshaft front and rear
IN LINE
M ARK IV V-8
WASHER
Fig. 6 2 —Sprocket or Gear Replacement
S M A L L
V - 8 "
bearings by driving towards center of cylinder
block (fig. 68).
INSTALLATION
The camshaft front and rear bearings should be installed
first. These bearings will act as guides for the pilot and
center the remaining bearings being pulled into place.
1. Assemble remover and installer tool on driver
handle and install camshaft front and rear bearings
by driving towards center of cylinder block (fig. 68).
INSTALLATION
J-5590
\J-5590]
i J-21058
OVERHAUL MANUAL