EFORE EGINNING NSTALLATION 1. Read and understand the entire manual. 2. Validate PAS kit contents. 3. PAS must be installed with the prescribed camera in the prescribed location. 4. Camera System must be installed and functional before installing PAS In order to save time in trouble shooting. Rostra PAS part number 250‐8883 has been designed to work directly with the 250‐ 8137/250‐8115 CAMERA ASSY ONLY! This product must be installed as per this instruction in order for it to function as designed, tested and advertised. 2 ...
Page 3
MERCEDES SPRINTER ‐ PARK ASSIST SYSTEM /CAMERA 2010‐2012 250‐8883 ART UMBER Remove Passenger side kick panel to gain access to Can Junction/ wires. (green w/white+ /green ‐) ...
Page 4
MERCEDES SPRINTER ‐ PARK ASSIST SYSTEM /CAMERA 2010‐2012 250‐8883 ART UMBER REARSIGHT (PAS) HE ENEFITS OF THE ARK SSIST YSTEM 1. Driving Trajectory – The PAS uses the steering angle sensor from the vehicle to create a graph of the vehicle’s backing trajectory. The system takes the guess work out of where the vehicle will end up when Backing‐Up. 2. Size Matters – Having enough room to park is always a question. Knowing the space is large enough and where the vehicle will end up reduces stress and anxiety over backing up whether backing into perpendicular or parallel parking places. 3. Blind spots do occur and so caution must always be used when driving in reverse. Note that the rear view and side view mirrors must be observed and also the front of the vehicle when using this product. This is not an ...
Page 5
MERCEDES SPRINTER ‐ PARK ASSIST SYSTEM /CAMERA 2010‐2012 250‐8883 ART UMBER REVERSE PARKING with the REARSIGHT Park Assist System (PAS) ...
Page 6
MERCEDES SPRINTER ‐ PARK ASSIST SYSTEM /CAMERA 2010‐2012 250‐8883 ART UMBER PARALLEL PARKING REAR SIGHT Park Assist System (PAS) WITH THE WILL IT FIT? ...
Page 7
MERCEDES SPRINTER ‐ PARK ASSIST SYSTEM /CAMERA 2010‐2012 250‐8883 ART UMBER ROUBLESHOOTING 1. Green Light on Mirror is Flashing: a. Verify that OBDII Connector from PAS system is plugged into OBDII connector on vehicle. b. Verify Video from PAS module to Mirror is connected. c. With Truck in Reverse Gear verify Voltage in the center of DC Connector coming from the PAS module has a reading of 10‐16 +VDC measured to ground. d. Verify connection to Accessory Power on Red Wire of PAS module measures 10‐16 +VDC measured to ground. 2. Directional arrow does not correlate to steering wheel position: a. Camera direction may need to be adjusted to calibrate position to arrow. ...