Advertisement
b. The power requirements plus the power
draw of the other equipment in the rack
must not overload the supply circuit and/
or wiring of the rack.
1.6 Wait up to two minutes for the FibreBridge
Ready LED to light indicating the
FibreBridge has completed its power-on
self test sequence.
2 Discover the IP address
Note
The FibreBridge is initially configured with DHCP
enabled. It is best if you have access to a DHCP server.
2.1 Work from the computer attached to the
FibreBridge Ethernet port on the same
domain.
Note
To find the IP address you need the ATTO QuickNAV
Go to attotech.com/downloads, sign in or register for an
account, then select FibreBridge 7500 on the Downloads page
to download QuickNAV.
2.2 Install QuickNAV and launch the program
to identify the FibreBridge.
2.3 Locate the FibreBridge with the serial
number recorded earlier.
2.4 Highlight the serial number.
2.5 Click Next.
If a DHCP server is available on your network,
an address is assigned automatically by the
server. Note the assigned address:
____________________________________
If you do not have a DHCP server, get an IP
address and subnet mask from your network
administrator, type it into the area provided,
and click on Next.
2.6 Click on Launch Browser
Your browser points to the ATTO
ExpressNAV splash screen. If you use
Internet Explorer as a browser, continue on to
Internet Explorer setup
below. If not, continue
on to
Begin initial configuration
.
3 Internet Explorer setup
3.1 Open your browser
3.2 Select Internet Options.
3.3 In the Internet Options screen, select the
Security tab.
3.4 Click on the Trusted Sites icon.
3.5 Click on the Sites button.
3.6 In the text box Add this Web site to the
zone, add the IP address of the appliance.
You may use wild cards.
3.7 Click on Add
3.8 Uncheck the Require server verification
check box.
3.9 Click OK.
3.10 At the bottom of the Internet Options box,
click on OK and close the box.
TM
.
tool.
4 Using FTP
4.1 Establish an FTP link to the bridge that is to
be flashed.
Note
The FibreBridge does not support passive mode. The FTP
connection must be set up for both active mode and binary
mode for the transfer to complete.
4.2 Use the PUT command to download the
firmware file to the bridge. For example:
PUT c:\bridge_firmware\at750100.zbd
4.3 Once the download is complete, cycle
power on the FibreBridge to implement the
new firmware.
5 Begin initial configuration
5.1 The ExpressNAV System Manager
welcome screen appears. Click on Enter
Here
5.2 Type in the user name and password.
Note
The default values are user name root and password
Password. The user name is case insensitive and the
password is case sensitive.It is best practice to change
the default user name and password.
5.3 You are now ready to configure the
FibreBridge for use. For more information,
refer to the Installation and Operation
Manual.
Exhibit 1 Brackets to install the FibreBridge into a rack
Exhibit 2 FibreBridge 7500D, LEDs, power receptacle
and ports
Advertisement
