Operation; Recommended Settings - Performax AntFi X60-2 User Manual

OPERATION

1.ADJUST THE WELDING HELMER ACCORDING TO YOUR INDIVIDUAL
REQUIREMENTS
The headband should be adjusted both in circumference and height.
The angle between face and helmet should also be adjusted and recommended
to be 10°-12°.
2. ON/OFF
The solar unit automatically switches ON when exposed to light.
3.SELECT THE SHADE NUMBER
ATTENTION!!
MAKE SURE that the Shade Adjustment Knob is on the ''5(9)-9(13)'' position,
NOT on ''GRIND'' position, before starting to weld.
Two ranges of shade numbers, 5-9 and 9-13 are available in the dark
state.(Fig.1)
Shade Adjustment Knob
-3-
(Fig.1)
The ranges can be selected by the Shade Range Select Switch as shown on
Fig.1.
If the Shade Selection Switch is on the ''5-9'' position, then the shade selection
on the Shade Adjustment Knob is from 5-9 (MIN-MAX).
If the Shade Selection Switch is on the ''9-13'' position, then the shade
selection on the Shade Adjustment Knob is from 9-13(MIN-MAX).
Once the Shade Range is selected, the shade number can be adjusted by
turning the Shade Adjustment Knob. The arrow of the knob indicates the shade
setting.
Set the Adjustment Knob to ''GRIND'' position for grinding applications. the
filter will stay at Shade Number 4 and will not react to any welding arcs.
MAKE SURE TO RESET the knob back to ''"5-9/9-13" position (NON-GRIND
mode) after grinding.

RECOMMENDED SETTINGS

Shade 8
Shade 5 6
Shade 10 Shade 11
REFERENCE ANSI Z49.1-2005
1
Shade Range Select Switch
Shade 9 Shade 10 Shade 11 Shade 12 Shade 13 Shade 14
Shade 11 Shade 12 Shade 13 Shade 14 Shade 15
7 8 9 10 Shade 11 Shade 12 Shade 14
Shade 12 Shade 13 Shade 14 Shade 15
-4-